Ariens 921030 quick start Step One Assemble Handlebars Attach Control Cables

Page 5

Step One: Assemble Handlebars

(Attach Control Cables)

1.Hook spring end of attachment control cable to the clutch arm.

2.Hook spring end of the traction control cable to the cable eyelet on back of frame.

NOTE: Make sure the cable remains in the groove of the pulley.

NOTE: This slide applies to

UNATTACHED handlebars ONLY

Image 5

Contents Quick Start Guide Step One Assemble Handlebars Step One Assemble Handlebars Unfold Lower Handlebar Step One Assemble Handlebars Attach Upper Handlebar Assembly Step One Assemble Handlebars Attach Control Cables Step One Assemble Handlebars Unfold Upper Handlebar Step One Assemble Handlebars Connect Headlight Wire Harness Step One Assemble Handlebar Step Two Install Discharge Chute Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Control Cable Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Step Nine Check Engine Crankcase Oil Ariens AX Step Ten Fill Engine Fuel Tank Ariens AX Step Eleven Starting Engine Ariens AX Starting Engine / Step a Choke Starting Engine / Step B Rocker Switch Starting Engine / Step C Fuel Shut Off Valve Starting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Additional Resources