5.Daylight Savings - Select “Yes” or “No,” then press ENTER.
6.Alignment Option Screen - “Setup: Align” displays. Press ENTER.
7.Select Alignment - “Align: Easy” displays. Press ENTER.
8.Set Alt/Az Home Position - Autostar then prompts you to set the telescope in the Alt/Az Alignment home position. To set your telescope in the "Alt/Az" home position (Fig. 18):
•Loosen the telescope’s Alt lock (22, Fig. 1).
•Level the tripod base and the optical tube.
•Tighten the Alt lock (22, Fig. 1) to a firm feel only.
•Loosen the Az lock (19, Fig. 1) and turn the telescope horizontally until it points North. See LOCATING THE CELESTIAL POLE, page 32 for more information.
•Tighten the Az lock (19, Fig. 1). Press ENTER.
9 . Star Alignment - Autostar then chooses two stars to align upon. When the telescope slews to the first star for alignment, it may not appear in the field of view in the eyepiece. The alignment star should be easily recognized and be the brightest star in the area of the sky where the telescope is pointing. Use the Arrow keys to move the telescope until the star is visible and centered in the eyepiece. Press ENTER. Repeat procedure for the sec- ond alignment star.
When the procedure is performed correctly, "Alignment Successful" displays. If Autostar does not display this message, perform this procedure again.
NOTE: Autostar locates alignment stars based on the date, time, and location entered. The alignment stars may change from night to night. All that is required is for the observer to center the selected stars in the eyepiece when prompted.
NOTE: The GO TO key also allows you to perform a "spiral search." A spiral search is useful when the telescope slews to an object, but that object is not visible in the eyepiece after the telescope finishes its search. (This sometimes occurs during an alignment procedure.) Press GO TO when the slew is finished and the telescope starts slewing in a spiral pattern at a very slow speed around the search area. Look through the eyepiece and when the object does become visible, press MODE to stop the spiral search. Then use the Arrow keys to center the object.
Two other methods of alignment are available to the observer:
Two-Star Alt/Az Alignment
One-Star Alt/Az Alignment
IMPORTANT NOTE: The accuracy of
18