iOptron G-MC90, G-R80, G-N114 instruction manual Telescope Assembly, Attaching the Mount

Page 7

2. Telescope Assembly

Step 1. Preparing the Tripod

Extend tripod legs to full extension.

Step 2. Attaching the Mount

Attach mount to tripod using the long bolt (#7). Slide tray on bottom of shaft. Then screw on round black knob (#9).

Step 3a. Installing Batteries (not included)

Note: you may use 8 AA batteries (Step 3) or the AC adaptor (Step 5) to operate the mount.

Pull the batteries compartment cover (shown) open. Gently pull the batteries holder (shown next) out of the compartment to avoid breaking the attached wires.

Step 3b.

Insert 8 AA batteries (not included) according to the diagrams on the holder. Refer to the diagram on the holder to orient the batteries properly. Replace the holder back into the batteries compartment and replace the cover.

For reference: the battery pack fits in with wires on the bottom right (See arrow in photo). Use only fresh batteries. Using/mixing old or low batteries may cause error messages.

Optional AC Adapter and Car Charger accessories are available at www.ioptron.com

Step 4. Attaching Telescope

Dovetail Attach telescope to mount using the dovetail lock knob (#2).

lock (#2) (Picture shows 80mm refractor. However all scopes will attach in the same manner.)

7

Image 7

Contents SmartStar-G Series Mount and Telescopes Table of Content Never USE a Telescope to Look AT the SUN SmarStar-G Series Overview SmartStar-G Series FeaturesFor Model 8802 SmartStar-G-R80 Assembly Terms Attaching the Mount Telescope AssemblyFor 90mm Maksutov Flip switch Eyepiece Key Description Gotonovatm 8402G Hand ControllerHC LCD Information Screen LCD ScreenGetting Started Setting Up the MountLevel and Align the Mount Do not Count Daylight Saving Time Go to the Moon Using your telescopeInitial Star Alignment Slew to an Object Use SmartStar-G TelescopesTurn Off the Mount Manual Operation of a TelescopeLand Objects Sync to Target Electric Focuser Set Up ControllerAlign 1. R.A. and DEC User Object ListOne Star Align Two Star AlignmentAdd a new comet Delete allWatch List Reset comet dataPark Scope Maintenance and ServicingMaintenance Set Telescope CoordImages through the eyepiece appear unfocused or distorted TroubleshootingError Message Warning! Motor driver overloaded Cannot seem to focus No image appears in the eyepieceIOptron Customer Service Newtonian Reflector Telescope Appendix A. Technical SpecificationsSmartStar Goto Mount Refractor TelescopeMenu Appendix B. Gotonovatm 8402G HC Menu StructurePage Gotonova Deep Sky Object List Appendix C. Gotonovatm Star List5373 Messier Modern Constellations Gotonova Named Star List Gotonova Double Star List Install PL-2303 usb2com driver Appendix D. Set Up USB-PC ConnectionClick Next When finished installation, click Finish Install the Hardware Page Appendix E. Firmware Upgrade Page Typical Errors Appendix F. Use a PC to Control an iOptron Mount Ioptron ONE Year Limited Warranty