HOW to USE Your NEW Telescope

Astronomical telescopes are designed such that the image you see will appear

UPSIDE DOWN and REVERSED, this is acceptable for viewing celestial bodies. However, this special telescope offers an Erect Image Eyepiece which will deliver a 30x view that will NOT BE UPSIDE DOWN or REVERSED. This 30x eyepiece is recommended for viewing either land or night sky based objects.

Using your Eyepieces:

1.You should always start viewing with the lowest power eyepiece, which in this case is the 30x lens. This 30x erect image eyepiece is unique and will correct images to appear right side up as you view them through the telescope. This is especially beneﬁcial when viewing objects on land. Note: While images will not be upside down, they may appear tilted slightly. This apparent tilt is due to your viewing position with relation to the telescope. Depending on where you place your eye, the image tilt will vary. The important feature of this eyepiece is that the image is right side up and correct left to right (not a mirror image). This eyepiece is recommended for either land or sky viewing.

2.The 4mm lens is a traditional telescope eyepiece and will provide an image that on land will very clearly deliver an image that is upside down. However, this is normal and becomes unimportant as you view objects in the night sky. This eyepiece is recommended for sky viewing only.

Focusing Telescope:

1.After selecting the desired Eyepiece (3), aim Main Telescope Tube (14) at a land-based target at least

200yards away (e.g. A telephone pole or building). Fully extend focusing tube by turning Rack and Pinion

Focusing Mechanism (2).

2.While looking through selected Eyepiece (3) (in this case the 30x), slowly retract focusing tube by turning Rack and Pinion Focusing Mechanism (2) until object comes into focus.

Aligning and Using Red Dot Finderscope:

1.Remove plastic insert on bottom side of ﬁnderscope to allow battery to make connection with battery contact for power. Turn power switch on.

2.Look through main telescope tube at low power and establish a well-deﬁned stationary target. Looking through red dot ﬁnderscope, alternate tightening each adjustment wheel (at rear and side of ﬁnderscope) until the red dot of ﬁnderscope is precisely aligned and centered on the same object being viewed in main telescope tube.

Never Look Directly At The Sun With Your Telescope

Permanent Damage To Your Eyes May Result.