Vogue Industrial ABOVE GROUND SWIMMING POOL Stage 3 Filter & Pump Installation Plumbing Layout

STAGE 3 - FILTER & PUMP INSTALLATION - PLUMBING LAYOUT

VOGUE ABOVE GROUND POOL :- PLUMBING LAYOUT

P/P SOCKET	P/T SOCKET	P/T NIPPLE	90 deg. ELBOW	GLUE	P.T.F.E TAPE	3m x 1.5” ABS PIPE
UNION	UNION	SOCKET

					P/T NIPPLE			THR. HOSE TAIL
					SOCKET				S.S CLIP
	SKIMMER							FILTER
						IN	SE	WASTE
				FLEXIBLE PLUMBING
						R
				(supplied with filter)				CLOSED
		P/T SOCKET				RECIRCULATE
	P/T NIPPLE								FLEXIBLE
		UNION							BACKWASH
	SOCKET							BACKWASH
									WASTE HOSE
			Ball Valve
INLET		P/P SOCKET
		UNION				SAND FILTER
		Open	Closed
			PUMP
POOL			UNION
WALL					P/P SOCKET
					UNION
			Ball	PUMP	6” FROM
		SUCTION			GND LEVEL
			Valve

GROUND LEVEL

FLOW

Prior to installing the filter and pump, please study the plumbing layout plan as shown above. Included in the pool kit is small amount of plumbing fittings and pipework to enable you to site the filtration unit 2.5 metres away from the pool. However, plumbing configurations may vary in accordance with site conditions, ancillary equipment etc. therefore, extra plumbing may be purchased from your dealer.

If you intend to bury the pipework beneath ground level as per the diagram, please ensure that P/P Socket Unions are used to enable you to drain the pipe(s) for the Winter season.

All threaded fittings must have P.T.F.E (supplied) applied to them. Apply a minimum of 20 wraps of P.T.F.E onto a threaded fitting in a clockwise direction. As an extra precaution. it is a good idea to apply a thin film of Silicone

Sealant prior to screwing the fitting into a threaded socket.

Make sure that all pipework enters all the fittings correctly i.e. at least 3/4” of pipe should enter fitting.

All pipe work supplied is manufactured in ABS or PVC. DO NOT be tempted to use alternative pipe i.e Wastepipe, OSMA etc it is not suitable for pool filtration. Source extra pipework if required from your dealer.

Cut all pipework with a Hacksaw. Clean and de-bur edges with sand paper prior to applying glue. Use ABS/PVC glue only and liberally to both fittings. Leave 24 hrs to fully cure.

TIP!

Dry fit all fittings together prior to gluing fittings. Once glue has been applied it will be impossible to remove any fittings!

Ideally allow 24 hrs for glue to fully cure.

Do not glue fittings unless you are entirely sure that all pipework is in the correct position. Once glue has been applied, you will not be able to remove or adjust any fittings!

Any water or air leaks that appear when filtration has started will require glued or threaded fittings to be re-made.

9