Step 2.
Lift top frame of cradle, and turn handle so that it lines up with the plastic hinges.
Step 3.
Snap handle and hinges together to lock. Be sure handle is locked into the plastic hinges.
Step 4. | Hanger |
Place cradle in hanger. |
|
Be sure handle notches are |
|
seated in the hanger. |
|
Step 5. | Notch |
|
Adjusting the Handle
To bring infant carrier handle from resting position into posi- tion for carrying or swinging, first set the carrier down. Then push down on center of handle, and rotate the handle forward until it clicks into the locked position.
To return the handle to resting position, first set the carrier down. Then push down on center of handle, and rotate the handle backward until it clicks into place.
NOTE: It is normal for the handle to seem loose in the resting position.
Push down
on center of handle
Push down
on center 
of handle
Place your child in the cradle. |
Step 6.
Set the control switch between the low and medium positions. Your cradle will swing properly only in the lower range.
Step 7.
Give cradle a push to start the swinging motion.
Using the
Infant Carrier
Lift carrier in and out of swing.
Do not adjust the handle while carrier is on swing.
Different uses for infant carrier...
Cuddler | Carrier | Feeder |
| ...or as a Rocker. |
|
| 7 |
|
Using the Tray
Unlatch the tray by squeezing the two latches under the tray at the same time, and lift up tray. Be careful not to let tray hit your baby when lifting or closing tray.
To latch tray, push down firmly.
Tray must be latched at all times when baby is in the swing.
Adjusting the Stand
To change recline of the carrier, squeeze the adjustment wire and move to desired position.
To adjust for rocking, move the adjustment wire to the highest position.
Do not change recline with baby in infant carrier.
Be aware that infant move- ment or rocking may cause the infant carrier to move on a table.
8