OPERATION
Set-up
1.Before you begin binding you need to attach the handle to the machine. Unscrew the gray handle knob on the right side of the machine by turning the knob to the left. Place the handle onto the metal square and insert the knob into the handle. Turn the knob to the right to tighten and hold handle in place.
2.Make sure the machine is on a flat, sturdy surface.
3.Check to make sure the paper waste tray is empty and correctly fitted.
4.Lift the cover and the punching handle to the upright position.
5.Move the adjustable paper edge guide to the size of paper you wish to punch.
6.Push the margin depth knob up or down to adjust the margin on the paper from 1/10˝ to 1/4˝.
7.Select the
NOTE: Test pieces of scrap paper to make sure everything is aligned properly before punching your finished document.
Punching and Binding
1.Slide the front and back covers into the paper entry lengthwise. Pull the handle down to punch.
2.Punch the remaining sheets in small batches that do not overload the machine. This machine can punch 15 sheets of 20lb./80gsm paper at one time.
3.Place the binding comb in between the comb pins with the open side facing up. Slowly push back the handle to have the comb pullers open up the combs wide enough to insert the punched sheets. This machine binds up to 300 sheets using a 1 1/2˝ comb.
4.Insert the punched sheets onto the open binding comb. For the best results, insert the front cover face down first, then insert the rest of the sheets and back cover.
5.When all of the sheets are loaded onto the comb, pull the handle back to its original position. Remove the bound document by lifting it up.
7