1.Turn off the projector and unplug the AC power cord.
2.Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can access the lamp cover.
3.Remove the access panel screws and open the panel.
4.Remove the screws on the bottom of the lamp assembly.
5.Grasp the lamp handle and pull the lamp assembly directly out of the projector.
6.Replace with the new lamp.
7.Place back the screws on the bottom of lamp assembly.
8.Place the panel and screw back the screws on the lamp cover.
NOTE
Dispose of the used lamp according to local regulations.
Ensure that screws are tightened properly. Screws not tightened fully may result in injury or accidents.
Since the lamp is made of glass, do not drop the unit and do not scratch the glass.
Do not reuse the old lamp. This could cause the lamp to explode.
Be sure to turn off the projector and unplug the AC power cord before replacing the lamp.
Do not use the projector with the lamp cover removed.
ViewSonic PJ402D | 35 |