ViewSonic SCZ55BKUS0 manual Store Screws inside the Bracket

Setting Up Your SC-Z55

Positioning Your SC-Z55

Step 3: Store Screws inside the Bracket

To store screws inside the bracket, please do the following:

NOTE

• It’s highly recommended to store screws inside the bracket when not needed to prevent them getting lost.

1.Place a sheet of paper or a piece of cloth on a flat surface, and then put your bracket on that paper or cloth with the screw storage side upward.

2.Place the screw upon its storage space, and push the screw into the space with your finger until it clicks into place. For the smallest-size screw, use the tip of a screwdriver instead to push the screw.

NOTE

• Please refer to the figure and descriptions in “Step 2: Understand Your Stand / VESA Mount Kit for SC-Z55”5” for the correct storage space of each screw.

Step 4: Remove Screws from the Bracket

To remove screws stored inside the bracket, please do the following:

1.Place a sheet of paper or a piece of cloth on a flat surface, and then put your bracket on that paper or cloth with the screw storage side downward.

2.Insert the tip of a screwdriver into the square holes to remove the desired screws from the bracket.

Square Hole

10