Eiki LC-XB23C Lamp Replacement, Reset the lamp replacement counter, Service Parts No 323

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an end, the LAMP REPLACE indicator emits a yellow light. If this indicator lights yellow, replace the lamp with a new one promptly.

	This indicator is yellow when
	the life of the projection lamp
WARNING:
	draws to an end.

TURN OFF THE UV LAMP BEFORE

OPENING THE LAMP COVER

Top Control

POWER WLAMP REPLACE

ON	INPUT	KEYSTONE
SELECT
VOLUM		+
		VOLUME
-
E

CAUTION

Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp.

1	Turn off the projector and disconnect the AC power
	cord. Allow the projector to cool for at least 45
	minutes.
2	Remove the screw with a screwdriver, and remove
	the lamp cover.
3	Remove 2 screws of the lamp with a screwdriver and
	pull out the lamp by grasping the handle.
4	Replace the lamp with a new one and tighten the 2
	screws back into position. Make sure that the lamp is
	set properly. Replace the lamp cover and tighten the
	screw.
5	Connect the AC power cord to the projector and turn
	on the projector.
6	Reset the lamp replacement counter.
	See “Lamp Replacement Counter” on the next page .

Lamp Cover Screw

Screw

Lamp

Screw Handle

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

●	Model No. of your projector	: LC-XB23C
●	Replacement Lamp Type No.	: POA-LMP90
		(Service Parts No. 610 323 0726)

52