Eiki LC-X2UL Turn the Main ON/OFF switch to on, Press the Power ON/OFF switch to on, Back on

Follow these steps to clean the projection lens:

1.Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.

Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.

2.Lightly wipe the cleaning cloth over the lens.

3.When you don’t use the projector, replace the lens cover. -

Before calling your dealer or service station for assistance, check the matters below once again.

1.Make sure you have connected the projector to your equipment as described in section “CONNECTING THE PROJECTOR” on pages 14- 21. - - -

2.Check cable connections. Verify that all computer, video and power cords are properly connected.

3.Verify that power is switched on. -

4.If the projector still does not display an image, re-start the computer.

5.If the image still does not display, unplug the projector from the computer and check the computer monitor’s display. The problem may be with your graphics controller rather than with the projector. (When you reconnect the projector, remember to turn the computer and monitor off before you power up the projector. Power the equipment back up in order of:

Projector and computer)

6.If the problem still exists, check the following chart.