Eiki LC-W4 instruction manual Fig-9

7Adjust the focus of the Projection Lens. (LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z, LNS-W03, and LNS-W07 only.) Set up the projector and project an image on the screen. Loosen the Focus

Lens Lock Screw and rotate the Projection Lens to obtain a proper focus. After adjusting the focus, be sure to lock the Projection Lens with the Focus Lens Lock Screw securely. (See Fig. 5.) Adjust the focus of the Projection Lens MODEL LNS-W03 by following the Focus Adjustment on page 6.

8Replace the Upper Lens Cover. Fix the Upper Lens Cover with four (4) Screws C. (See Fig.2.) Except the Model LNS-W01, LNS-W01Z, LNS-T01, and LNS-T01Z, proceed with the following.

Slide the Light-Block Sheets into the guide of the Upper Lens Cover and set them in front of the flap. (See Fig. 9.)

9Replace the Lower Lens Cover. Fix the Lower Lens Cover with two (2) Screws A. (See Fig.1.) Except the Model LNS-W01, LNS-W01Z, LNS-T01, and LNS-T01Z, proceed with the following.

Slide the Light-Block Sheets into the guide of the Lower Lens Cover and set them in front of the flap. (See Fig.9.)

10	Turn the projector on and operate the Lens shift, Zoom, and Focus fully to check the Light-Block
	Sheets. If the Light-Block Sheets interfere with those operations, check if the Light-Block Sheets

are set properly.

Slide both upper sides of LIGHT BLOCK

Sheets in between 1	and 2 .
Slide into front	FLAP
of the flap.

1UPPER LENS COVER

2GUIDE

LIGHT-BLOCK

SHEETS

FLAP	LOWER LENS
	COVER

E

Fig-9

- 5 -