COMPUTER MODE
AUTO IMAGE FUNCTION
The Auto Image function is provided to automatically adjust
Fine sync, Total dots, and Picture Position for most computers.
1Press the MENU button and the
2Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN button. Change the setting On or Off by pressing the SELECT button.
Fine sync
Adjust the picture as necessary to eliminate flicker from the display.
This item can be adjusted manually. (Refer to page 26.)
Total dots
The number of the total dots in one horizontal period. This item can be adjusted manually. (Refer to page 26.)
Position
Adjustment of the position of the image. This item can be adjusted manually. (Refer to page 27.)
3Move the arrow to “Go!” and press the SELECT button to start the Auto Image function.
This adjustment can be executed by pressing AUTO IMAGE button on the Remote Control Unit.
Stored
Go
Quit
NOTE:
Stores the On/Off setting of each item.
Starts the Auto Image Function.
Closes the AUTO IMAGE FUNCTION Menu.
The Fine sync and the Total dots cannot be fully adjusted when “RGB,” “HDTV1O35i” or “HDTV1O8Oi” is selected on the SYSTEM MENU (P22 and 23).
The Fine sync, Total dots, and Picture Position of some computers may not be fully adjusted with the Auto Image Function. In that case, manual adjustment is required to make fine image. (Refer to page 26 to adjust “Fine sync” or “Total dots” and page 27 to adjust Picture Position.)
PICTURE POSITION ADJUSTMENT
The position of the image can be adjusted vertically and horizontally through PICTURE POSITION ADJUSTMENT.
1Press the MENU button and the
2Move the image by pressing the POINT UP / DOWN / RIGHT / LEFT buttons.
To cancel PICTURE POSITION ADJUSTMENT, press any button except POINT buttons. To return to the position previously set, press NORMAL button.
27