Intel ET900 Video Off Method, Video Off In Suspend, Suspend Type, Modem Use IRQ, Suspend Mode

Page 32

BIOS SETUP

Video Off Method

This field defines the Video Off features. There are three options.

V/H SYNC + Blank

Default setting, blank the screen and turn

 

off vertical and horizontal scanning.

DPMS

Allows BIOS to control the video display.

Blank Screen

Writes blanks to the video buffer.

Video Off In Suspend

When enabled, the video is off in suspend mode. The default setting is Yes.

Suspend Type

The default setting for the Suspend Type field is Stop Grant.

Modem Use IRQ

This field sets the IRQ used by the Modem. By default, the setting is 3.

Suspend Mode

When enabled, and after the set time of system inactivity, all devices except the CPU will be shut off.

HDD Power Down

When enabled, and after the set time of system inactivity, the hard disk drive will be powered down while all other devices remain active.

Soft-Off by PWRBTN

This field defines the power-off mode when using an ATX power supply. The Instant Off mode allows powering off immediately upon pressing the power button. In the Delay 4 Sec mode, the system powers off when the power button is pressed for more than four seconds or enters the suspend mode when pressed for less than 4 seconds.

Wake up by PCI Card

By default, this field is disabled.

Power On by Ring

This field enables or disables the power on of the system through the modem connected to the serial port or LAN.

28

ET900 User’s Manual

Image 32
Contents USER’S Manual VersionAcknowledgments Table of Contents ET900 945GM COM Express CPU Module Introduction Product DescriptionChecklist ET900 Specifications LvdsDimensions Installing the Processor Installing the Memory Installing and Removing Memory ModulesConnectors on ET900 J2, J3 COM Express Type 2 ConnectorsRow a Row B Row C Row D Pin Signal PEGRX0+ This page is intentionally left blank Bios Setup Bios Introduction Bios SetupPhoenix AwardBIOS Cmos Setup Utility Standard Cmos Setup DateDrive a / Drive B TimeIDE Channel Master/Slave Video Halt OnAdvanced Bios Features CPU FeatureHard Disk Boot Priority Virus WarningQuick Power On Self Test First/Second/Third Boot DeviceBoot Other Device Boot Up Floppy SeekTypematic Delay Msec Apic ModeSecurity Option MPS Version Control for OSAdvanced Chipset Features Dram RAS# to CAS# DelayDram Timing Selectable CAS Latency TimePrecharge Delay tRAS System Bios CacheableVideo Bios Cacheable On-Chip VGA SettingPanel Scaling Panel NumberIntegrated Peripherals OnChip IDE DeviceIDE HDD Block Mode On-chip Primary PCI IDE EnabledOnChip Primary/Secondary PCI IDE IDE Primary/Secondary Master/Slave PIOOn-Chip Serial ATA Setting Power on FunctionKB Power on Password Hot Key Power onPwron After PWR-Fail Uart Mode SelectOnboard Serial Port Power Management Setup RUN Vgabios if S3 ResumePower Management Acpi FunctionSuspend Mode HDD Power DownPower On by Ring Video Off MethodResume by Alarm Reload Global Timer EventsPNP/PCI Configurations CPU Warning Temperature Temperatures/VoltagesShutdown Temperature PC Health StatusSpread Spectrum Modulated Frequency/Voltage ControlAuto Detect PCI Clk Load Fail-Safe Defaults Load Optimized DefaultsSet Supervisor Password Save & Exit SetupThis page is intentionally left blank Drivers Installation Intel Chipset Software Installation Utility Click IntelR Chipset Software Installation UtilityDrivers Installation VGA Drivers Installation Click IntelR I945GM Chipset Family Graphics DriverDrivers Installation Click Realtek Codec Audio Audio Driver Drivers Installation Intel PRO LAN Drivers Installation Click Install Base Software to continueMarvell LAN Drivers Installation IP400 carrier board only Drivers Installation