Intel 8205 quick start Existing Dhcp Server on, Connect a PC directly to the Router

Page 9

Scenario Descriptions

Scenario 3

Existing DHCP Server on the

LAN

If your LAN uses an existing DHCP server, complete the following steps to get Internet access through the DSL or cable modem.

Connect a PC directly to the Router

1Use the provided blue cable to connect a PC to the router’s LAN 1 port. You must temporarily remove this PC from the network.

2On the back of the router, set the Hub/PC switch to “PC”.

3Configure the PC to obtain an IP address from a DHCP server. See the documentation that came with your PC for instructions on this setting.

4Restart your PC; otherwise you will not be able to contact the router.

Disable the DHCP server on the router

1If it is not already open, start Intel® Device View.

2In the Discovered Device Tree, expand the Subnet 192.168.1 (see Figure 11).

3Double-click on 192.168.1.1 (the default IP address for LAN 1).

4From the Configuration menu, select DHCP Server Setup.

5Clear the Enable DHCP Server check box.

6Click OK.

Internet

PC

DSL/cable modem

Input
5.1VDC/2.6A
				Console
	Recovery		Hub	PC
	Recovery		II	X
Power	WAN	LAN 2	LAN 1
		10 Mbps	10 / 100 Mbps

7070	Set this switch to “PC”

Figure 10. Connect a PC directly to the router.

Figure 11. Open the router for management.

Figure 12. Disable the router’s DHCP server.

7

Image 9

Contents Intel Express 8205 and 8205 with VPN Routers First Edition October A43586-001 Contents Connect the power Install the Router HardwareConnect the LAN 1 port to your local network Connect the LAN 2 port to your DSL or cable modemSelect a Scenario To reset the router to factory defaults Parameter SettingScenario Descriptions LAN PCs Get IP Address from Dhcp Server on RouterInstall Intel Device View Install Intel Device View for Scenarios 2, 3,Firewall Filters and NAT for Scenarios 2, 3, and 4 See For non-Windows* operating systemsFirewall filtering and local servers Connecting to a Cable ModemDisable the Dhcp server on the router Existing Dhcp Server onConnect a PC directly to the Router Change the LAN 1 IP address Restore your network connectionsConfigure a static IP address on LAN Static IP Address from ISP and Server Access on LANFirewall Filters and NAT Access internal servers from the InternetFirewall Filtering and NAT for Servers on the LAN Create firewall filters for LAN usersSetting up a VPN Tunnel Using the VPN OptionTo add a VPN tunnel For more information about VPN tunnelsVPN Tunnel Example Change the default IP address on LANBranch Office Setting Change the range of IP addresses used by the Dhcp serverStart the VPN Tunnel Wizard Firewalls and network address translation Connecting Two Branch OfficesVPN Tunnel Worksheet