T E C H N I C A L S P E C I F I C A T I O N S
Intel® Desktop Board D915GVWB
Processor
Processors Supported | • Intel® Pentium® 4 processors with 800-MHz |
| system bus in the LGA775 package |
| • Intel® Celeron® D processors with 533-MHz |
| system bus in the LGA775 package |
| •Supports boxed Intel® processors with packaging |
| designated by 04A or 04B Platform Compatibility |
| Guide |
Intel® 915GV Express | • Intel® 82915GV Graphics Memory Controller Hub |
Chipset | (GMCH) |
| • Intel® 82801DB I/O Controller Hub (Intel® ICH6) |
| • Firmware Hub (FWH) |
Graphics Memory | Designed to support up to 4 GB1 of system memory |
Controller Hub (GMCH) | using DDR400/333 SDRAM memory |
Intel® ICH6 I/O Controller Hub | • Four SATA (1.5 Gb/s) ports |
| • Up to two ATA 100/66 devices |
| • Intel® PRO 10/100 network connection (optional) |
I/O Features | • Integrated super I/O LPC bus controller |
| • One PCI Express* x1 local bus slot |
| • Two PCI local bus slots |
USB 2.0 | Integrated Intel® ICH6 controllers: |
| • Four back-panel ports (two dual stack) |
| • Four front-panel ports (via 2-headers requiring |
| cabling to front panel) |
Firmware Hub
System BIOS | • 4-Mb Flash EEPROM featuring the Intel® Platform |
| Innovation Framework for EFI Plug and Play, IDE |
| drive auto-configure |
| • Advanced configuration and power interface V1.0b, |
| DMI 2.0, multilingual support |
Intel® Rapid BIOS Boot | • Optimized POST for faster access to PC from |
| power-on |
System Memory
Memory Capacity | • Four 184-pin DIMM connectors supporting up to |
| two double-sided DIMMs |
Memory Types | • DDR400/333 SDRAM Memory Support |
| • Non-ECC RAM (ECC memory will attempt to run |
| in Non-ECC mode only) |
Memory Modes | • Dual- and single-channel operation support |
Memory Voltage | • 2.5V |
Hardware Management Features
•Processor fan speed control
•System chassis fan speed control
•Voltage and temperature sensing
•Fan sensor inputs used to monitor fan activity
•Power management support for ACPI 1.0b
Wake-Up From Network
•Wired for Management (WfM) 2.0-compatible
•Support for system wake-up using an add-in network interface card with remote wake-up capability or integrated LAN
Expansion Capabilities
•Two PCI bus add-in card connectors
•One PCI Express* x1 bus add-in card connector
Jumpers and Front-Panel Connectors
Jumpers | • Single configuration jumper design |
| • Jumper access for BIOS configuration mode |
Front-Panel Connectors | • Reset, HD LED, Power LEDs, power on/off |
| • Two front-panel Hi-Speed USB 2.0 headers |
| • Front-panel audio header |
Mechanical
Board Style | • MicroATX 1.0-compliant |
Board Size | • 9.6" x 9.6" |
Baseboard Power
Requirements• ATX 12V or SFX 12V
Environment
Operating Temperature | • 0° C to +55° C |
Storage Temperature | • -40° C to +70° C |
Regulations
Safety Regulations
U.S. and Canada | UL 1950, Third edition—CAN/CSA C22.2 No. 950-95 |
| with recognized U.S. and Canadian component marks |
Europe | Nemko* certified to EN 60950 |
International | Nemko certified to IEC 60950 (CB report with CB |
| certificate) |
EMC regulations (tested in representative chassis) |
U.S. | FCC Part 15, Class B |
U.S. | FCC Part 15, Class B open-chassis (cover off) testing |
Canada | ICES-003, Class B |
Europe | EMC directive 89/336/EEC; EN 55022:1998 Class B; |
| EN 55024:1998 |
Australia/New Zealand | AS/NZS 3548, Class B |
Taiwan | CNS 13438, Class B |
International | CISPR 22:1997, Class B |
Power requirements vary. Complies with US CRF via EN55022 +6 db in system configurations with an open chassis and EU Directive 89/336/EEC and use via EN55022 and EN50082-1 in a representative chassis.
Ordering Information
See Intel’s Web site at www.intel.com
For the most current product information available, visit Intel’s Web site at:
developer.intel.com/design/motherbd/
1Intel® Desktop Board D915GVWB was designed to support up to 4-GB total system memory using DIMMs based on 512-Mbit or 1-Gbit technologies. 1-Gbit technology has not been validated on this Intel® desktop board. For more information about the latest list of tested memory, refer to the Intel World Wide Web site at: http://support.intel.com/ support/motherboards/desktop/
INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH INTEL® PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY THIS DOCUMENT. EXCEPT AS PROVIDED IN INTEL’S TERMS AND CONDITIONS OF SALE FOR SUCH PRODUCTS, INTEL ASSUMES NO LIABILITY WHATSOEVER, AND INTEL DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY, RELATING TO SALE AND/OR USE OF INTEL PRODUCTS INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
Intel products are not intended for use in medical, life-saving, or life-sustaining applications. Intel may make changes to specifications and product descriptions at any time, without notice.
All products, dates and figures specified are preliminary based on current expectations, and are subject to change without notice. Availability in different channels may vary.
The Intel® desktop boards, processors, and chipsets may contain design defects or errors known as errata, which may cause the product to deviate from published specifications. Current characterized errata are available on request.
Intel, Pentium, Celeron, and the Intel logo are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries.
*Other names and brands may be claimed as the property of others.
**Intel® Desktop Utilities includes: hardware monitoring, Diskeeper* Lite defragmentation, NTI Backup Now*, StressTest*, Symantec* Security Check
† Available by Internet download only. Third-party user registration required.
Copyright © 2004 Intel Corporation. All rights reserved. | 1104/MS/AT/PDF C304563-001 |