Intel SOM-4486 user manual Fcc

Page 4

FCC

Caution!

This device complies with the requirements in part 15 of the FCC rules: Operation is subject to the following two condi- tions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, includ- ing interference that may cause undesired operation

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruc- tion manual, may cause harmful interference to radio commu- nications. Operation of this device in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his/her own expense. The user is advised that any equipment changes or modifications not expressly approved by the party responsi- ble for compliance would void the compliance to FCC regula- tions and therefore, the user's authority to operate the equipment.

There is a danger of a new battery exploding if it is incorrectly installed. Do not attempt to recharge, force open, or heat the battery. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batter- ies according to the manufacturer’s instructions.

SOM-4486 User’s Manual

iv

Image 4
Contents SOM-4486 ETX Module Copyright Acknowledgements Packing List Additional Information and AssistanceFCC Contents Appendix a Prog. Watchdog Timer General Information Introduction IntroductionSpecifications Standard System On Module functions2 VGA/flat panel Interface Audio function4 LCI Mechanical and environmentalBoard Dimensions SOM-4486 dimensionsBoard layout dimensions SOM-4486 Top viewSOM-4486 Solder view SOM-4486 User’s Manual Connector Assignments Descriptions Connector Locations Connector AssignmentsPin Assignments for X1/2/3/4 connectors Safety precautions SOM-4486 User’s Manual Software Configuration VGA display software configuration Utility CD diskBios VGA setup screen Connections for two channel Lvds SOM-4486PCI Graphic Setup Chipset Display memoryDisplay types Dual/Simultaneous DisplayPage Installation of the PCI Graphic driver Installation for Windows 98/ME/2000/XPPage SOM-4486 User’s Manual Further Information SOM-4486 User’s Manual Audio Setup Driver installation Before you beginWindows 9x/2000/Me/XP drivers SOM-4486 User’s Manual LAN Configuration Installation of Ethernet Driver FeaturesLCI Bus Ethernet Interface Installation for Windows SOM-4486 User’s Manual Page Further information Programming the Watchdog Timer Appendix a Prog. Watchdog Timer Watchdog programmingOUT DX,AL MOV DX,2FH MOV AL,00H MOV DX,2EH MOV AL,F6H SOM-4486 User’s Manual System Assignments Appendix B System Assignments System I/O portsDMA channel assignments Table B.2 DMA channel assignmentsInterrupt assignments Table B.3 Interrupt assignments1st MB memory map Table B.4 1st MB memory mapSOM-4486 User’s Manual