Model IW601
Mounting screws (6)
Installation:
Use the included template to mark and cut a hole in the drywall.
We recommend wiring with AWG 16 or larger, stranded wire.
For proper phasing, all speakers in the system must be wired alike. Connect red wires to red terminals on speaker and to red or plus terminals on amplifier.
Install the IW601 in the hole. Tighten the mounting screws. The mounting dog ears will rotate outward and grip the drywall.
Aim tweeter
Features:
High power handling capacity
2nd order crossover 12dB per octave with poly switch for tweeter protection.
6.5” polypropylene woofer with butyl rubber surround
1” pivoting soft dome tweeter
Gold speaker terminals
Small perforated designer grille
Mounting template and paint shield included
Recommended power: 20W to 100W
Specifications:
Frequency range: | 45Hz - 20kHz ± 3dB |
Sensitivity: | 90dB (1W/1m) |
Power Handling: | |
Drivers: | 1- 1” soft dome tweeter |
| 1- 6.5” polypropylene woofer |
Impedance: | 8 ohms |
Finish: | ABS plastic |
Dimensions: | 12.0”H x 8.75”W x 3.44”D* |
| *from surface of wall board |
Hole Size: | 10.625”H x 7.25”W |
Specifications subject to change without notice.
2 | 3 |