VMAC-1
ViewSonic® Macintosh® Adapter
User’s Guide
Quick Start Installation
1With the monitor and computer turned OFF, open the shielding door of the adapter.
2Make sure all dip switchs are set to default settings as shown in the illustration to the right.
(Resolution = 832 x 624 and Sync Mode = “Separate + Composite”)
3Close the shielding door.
4Connect the male side of the adapter to the monitor port on the back of the computer.
Tighten the two adapter thumb screws until snug. DO NOT
5Connect the video cable to the female side of the adapter, then connect the other end of the cable to the back of your monitor.
Tighten the thumb screws at both ends of the video cable until snug. DO NOT
6Turn on the computer and the monitor.
NOTE: To set the adapter to the highest resolution your Macintosh computer can use, follow the Advanced Settings procedure to the right.
To reach ViewSonic Customer Support call (800)
TopView with shielding door open |
|
|
Female video connector pins
Shielding door
Default Dip Switch
Settings
Up position = On |
|
|
(black) | Male video | |
| connector pins | |
CAUTION: Be careful not to bend the video connector pins.
Advanced Settings
1With the monitor and computer turned OFF, open the shielding door of the adapter.
2Check your monitor’s user guide for the maximum resolutions the monitor will support and then select the appropriate resolution from the Dip Switch Settings chart (to the left).
Copyright © ViewSonic Corporation, 1998. All rights reserved. ViewSonic is a registered trademark of ViewSonic Corporation. Macintosh is a registered trademark of Apple Computer, Inc.
NOTE: Your Macintosh computer may not support the maximum resolutions of your monitor.
3Using the tip of a pen, set each numbered dip switch on the adapter to ON or OFF according to the resolution you selected from the Dip Switch Settings chart.
4Close the shielding door.
5Turn on the computer and the monitor.