INSTALLATION
CONNECTIONS
Figure 5. Mounting the tweeter using the I-Mount flush-mounting kit.
1)push in
4)
blk 
–
+
red
3)
Open the crossover housing by firmly squeezing the sides of the top half and lifting it away from the bottom. Using screws or a wire tie, mount the crossover using the holes provided. Observing proper polarity, connect the speakers and amplifier as shown in Figures 8A and 8B. Replace the cover when you are finished making the connections and adjustments (see following section).
Figure 8B. Locating wiring connections on the GTO506c woofer. Other woofers are wired similarly.
2) turn
Figure 6. Aiming the tweeter at a desired listening position.
3. Rotate to aim angled tweeter toward listener.
1. Slide screw up or down to adjust tweeter angle.
2.Tighten nut and washer to lock angle settings.
4. Securely tighten the large hand nut.
Figure 7. Mounting the tweeter using the I-Mount surface-mounting kit.
blk –
+ red
1
2
Figure 8A. Wiring connections on the crossover network (shown with cover on).
Red
To AMPLIFIER
SPEAKER OUTPUTS To WOOFER Blk ToTWEETER
Big Lug =
Small Lug =