Lenovo S200, S206 manual Safety inspection guide

Page 9

Safety information

Safety inspection guide

The purpose of this inspection guide is to assist you in identifying potential unsafe conditions. As each machine was designed and built, required safety items were installed to protect users and service personnel from injury. This guide addresses only those items. You should use good judgment to identify potential safety hazards due to attachment of non-Lenovo features or options not covered by this inspection guide.

If any unsafe conditions are present, you must determine how serious the apparent hazard could be and whether you can continue without first correcting the problem.

Consider these conditions and the safety hazards they present:

Electrical hazards, especially primary power (primary voltage on the frame can cause serious or fatal electrical shock)

Explosive hazards, such as a damaged CRT face or a bulging capacitor

Mechanical hazards, such as loose or missing hardware

To determine whether there are any potential unsafe conditions, use the following checklist at the beginning of every service task. Begin the checks with the power off, and the power cord disconnected.

Checklist:

1.Check exterior covers for damage (loose, broken, or sharp edges).

2.Turn off the computer. Disconnect the power cord.

3.Check the power cord for:

a.A third-wire ground connector in good condition. Use a meter to measure third-wire ground continuity for 0.1 ohm or less between the external ground pin and the frame ground.

b.The power cord should be the type specified in the parts list.

c.Insulation must not be frayed or worn.

4.Check for cracked or bulging batteries.

5.Remove the cover.

6.Check for any obvious non-Lenovo alterations. Use good judgment as to the safety of any non-Lenovo alterations.

7.Check inside the unit for any obvious unsafe conditions, such as metal filings, contamination, water or other liquids, or signs of fire or smoke damage.

8.Check for worn, frayed, or pinched cables.

9.Check that the power-supply cover fasteners (screws or rivets) have not been removed or tampered with.

5

Image 9
Contents Lenovo IdeaPad S200/S206 Page Contents Lenovo IdeaPad S200/S206 About this manualSafety information General safety Electrical safety Lenovo IdeaPad S200/S206 Hardware Maintenance Manual Safety inspection guide Grounding requirements Safety notice Safety notices multilingual translationsLenovo IdeaPad S200/S206 Hardware Maintenance Manual Safety information Lenovo IdeaPad S200/S206 Hardware Maintenance Manual Safety information Lenovo IdeaPad S200/S206 Hardware Maintenance Manual Safety information Laser compliance statement Safety information Strategy for replacing FRUs Before replacing partsImportant notice for replacing a system board Strategy for replacing a hard disk driveOriginal part Important information about replacing RoHS compliant FRUsGeneral checkout What to do first Following are not covered under warrantyPower system checkout Checking the AC adapterChecking operational charging Checking the battery pack Restoring the factory contents by using Recovery Disc Set Related service informationPower-on password PasswordsHard-disk password Supervisor passwordPower management Screen blank stateSleep standby state Hibernation state Lenovo IdeaPad S200 Lenovo IdeaPad S206 Feature Description SpecificationsWlan Wwan Feature DescriptionStatus indicators On solid white Indicator MeaningBlinking OffHotkeys Fn key combinationsKey combination Description Hotkeys DescriptionScrew notices FRU replacement noticesPlastic to plastic Logic card to plasticRemoving and replacing an FRU Step Screw quantity Color Torque Battery packLenovo IdeaPad S200/S206 Removal steps of dummy cards Dummy cardRemoval steps of hard disk drive Hard disk driveLenovo IdeaPad S200/S206 Hardware Maintenance Manual Removal steps of Dimm DimmPCI Express Mini Card for wireless LAN/WAN When installing Removal steps of 3G Card 1060 3G CardRemoval steps of keyboard KeyboardLenovo IdeaPad S200/S206 Hardware Maintenance Manual Important notices for handling the system board System boardRemoval steps of system board Lenovo IdeaPad S200/S206 Removal steps of LCD unit LCD unitRemove the LCD unit in the direction shown by arrow b Removal steps of fan assembly and heat sink assembly Fan assembly and Heat Sink assemblyLenovo IdeaPad S200/S206 Removal steps of base cover, speakers and power assembly Base cover, speakers and power assemblyLenovo IdeaPad S200/S206 Lenovo IdeaPad S200/S206 Hardware Maintenance Manual Removal steps of LCD front bezel LCD front bezelRemoval steps of LCD panel, LCD cable and hinges LCD panel, LCD cable and hingesM2 × 3.5 mm, flat-head, nylokcoated Silver Kgfcm Removal steps of integrated camera Integrated cameraFront view LocationsRight-side view Bottom and Left-side view Parts list Overall Parts list-Overall RPM 7MM 500G HDD Winnie TP Pmma S200 LCD FRUs 17.3-in. HD TFT Keyboard Lenovo IdeaPad S200/S206 Hardware Maintenance Manual Lenovo IdeaPad S200/S206 Lenovo IdeaPad S200/S206 Hardware Maintenance Manual Miscellaneous parts Parts list-Miscellaneous partsAC adapters Parts list-3-pin AC adaptersParts list-3-pin power cords Power cordsLongwell LP-46+H03VV-F+LS-18 1m Israel Lenovo IdeaPad S200/S206 Lenovo IdeaPad S200/S206 Hardware Maintenance Manual Trademarks
Related manuals
Manual 41 pages 382 b Manual 45 pages 18.52 Kb

S200, S206 specifications

The Lenovo S200 and S206 are compact and versatile laptops designed to cater to the needs of both professionals and students. These devices blend productivity with portability, making them ideal for users who require efficient computing on the go.

The Lenovo S200 comes equipped with a sleek design that reflects modern aesthetics while ensuring durability. It features a 12.5-inch display, which strikes a balance between size and usability, making it easy to carry without sacrificing screen real estate. The S200 is powered by Intel's processors, providing users with reliable performance for everyday tasks such as browsing, document editing, and multimedia playback.

The S206 takes it a step further by incorporating touchscreen technology, enhancing user interactivity. The 11.6-inch display on the S206 is not only lightweight but also offers vivid colors and sharp graphics, perfect for presentations and streaming videos. With this touchscreen feature, users can navigate through their tasks more intuitively, mimicking the experience of using a tablet while retaining the functionality of a laptop.

Both models prioritize connectivity, offering USB ports, HDMI outputs, and an Ethernet slot, ensuring that users can connect to various devices and networks seamlessly. Additionally, they include integrated Wi-Fi and Bluetooth capabilities, facilitating easy wireless communication.

Another critical aspect of both the S200 and S206 is their battery life. Designed to endure long hours of use, these laptops ensure that users can work or study without frequent interruptions for charging.

In terms of security, Lenovo equips the S200 and S206 with features such as a one-touch recovery button, enabling users to restore their systems effortlessly in case of software issues. The devices also integrate Lenovo’s Trusted Platform Module (TPM) technology, enhancing data security by providing encryption and secure storage for sensitive information.

The Lenovo S200 and S206 serve as functional tools for anyone needing a combination of portability and performance. Whether utilized for educational purposes, business applications, or personal projects, these laptops offer a solid option for users seeking efficient technology that adapts to their dynamic lifestyles. With their robust features, advanced technologies, and user-centric designs, the S200 and S206 prove to be valuable assets in the ever-evolving landscape of computing.