Adjusting your monitor image
This section describes the user control features used to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Note: The direct access controls are blue.
Table
Icon | Control | Description |
| Input Change | Switches the video input source. |
|
|
|
| Image Setup | Activates automatic image adjustment. |
|
|
|
| Brightness | Direct access to Brightness adjustment. |
|
|
|
Using the On-Screen Display (OSD) controls
The settings adjustable with the user controls are viewed through the
Display (OSD), as shown below.
(picture 1) | (picture 2) |
To use the controls:
1.Press 
to open the main OSD menu(picture 1).
2.Use 
or 
to move among the icons. Select an icon and press 
to access that function. If there is a 
or 
, then press 
to select that function. Use 
or 
to make adjustments.
Press 
to save.
3.Press 
to move backwards through the
4.Press and hold 
for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold 
for 10 seconds to unlock the OSD and allow adjustments to the OSD.
5.Enables DDC/CI by default. Use OSD Exit Key, press and hold the
buttons for
5 seconds to disable/enable DDC/CI function. The words " DDC/CI Disable/DDC/ CI/Enable" shows on the screen.
6. Press "Exit Key" to enter the input Signal meun(picture 2) when the monitor is under the condition of "No sync","No Cable" or "power Saving Mode".press or to choose input signal. press "AUTOSCAN" to go back to Auto Scan mode.
Chapter 2. Adjusting and using your monitor