Installing the monitor driver in Windows 2000
Note: This section must be completed before continuing with the Windows 2000 automatic image setup.
1.Turn off the computer and all attached devices.
2.Ensure that the monitor is connected correctly.
3.Turn on the monitor and then the system unit. Allow the system to boot into Windows 2000.
4.Open the Display Properties window by clicking Start 
Settings 
Control Panel, select/enter into the Display control panel.
5.Click the Settings tab.
6.Click the Advanced button.
7.Click the Monitor tab.
8.Click the Properties button.
9.Click the Drivers tab.
10.Open the Upgrade Device Driver Wizard window by clicking on Update Driver, and then click Next.
11.Select “Display a list of the known drivers for this device so that I can choose a specific driver” option, and then click Next.
12.Click the Have Disk button. Click on the Browse button and navigate to the following directory:
X:\Monitor Drivers\Windows XP & Windows 2000
(where X is the drive letter designator for the
13.Select the "L190xC.inf" file and click the Open button. Click on the OK button.
14.Select Lenovo L190xC and click Next. The files will be copied from the CD to your hard disk drive.
15.Close all open windows and remove the CD.
16.Restart the system.
Note: On LCD monitors, unlike CRTs, a faster refresh rate does not improve display quality. Lenovo recommends using either 1280 x 1024 at a refresh rate of 60 Hz, or 640 x 480 at a refresh rate of 60 Hz.
Chapter 3. Reference information |