JBL ESC200 setup guide Troubleshooting, Eleven. Bass Boost, Tape

eleven. Bass Boost

TEST
BASS	INPUT 1/2
BOOST
PRO CONCERT HALL STEREO
– BASS	+	– TREBLE +
–		+
	CENTER
–		+
	VOLUME
	FRONT
LEFT		RIGHT
	REAR
	ESC200

VOLUME	CENTER	TREBLE	BASS	BASS	FRONT
+	+	+	+	BOOST
–	–	–	–	LEFT	BALANCE	RIGHT
					REAR

POWER INPUT 1/2 PRO LOGIC CONCERT HALL STEREO

BASS

BOOST

Troubleshooting

If you hear no sound at all, check the following:

•Make sure the processor/ amplifier is plugged into a live electrical outlet and that the power switch is on.

•Check the connections from the TV or VCR to the processor/amplifier.

•If using with a television, make sure the TV is on and a signal is present.

•If using with a VCR, make sure the VCR is playing

a tape.

•Check all connections between processor/amplifier and each of the speakers.

If one or more of the speakers does not play, check the following:

•Check all connections between processor/amplifier and each of the speakers.

•Adjust the balance controls from left to right and front to rear.

If you have very little bass output, check the following:

•Make sure the subwoofer is connected properly to the processor/amplifier.

•Experiment with placement of the subwoofer. Remember, place the subwoofer in a cor- ner to get maximum bass out- put from the system.

•Make sure “Bass Boost”

is on.

• Adjust “Bass” level.

If there is no sound coming from the rear speakers or the volume is very low, check the following:

•Check all connections between processor/amplifier and each of the speakers.

•Adjust the front-rear balance controls on the processor/amplifier.

•Make sure the TV show or movie you are watching is recorded in Dolby* Surround. If it is not, try the “Concert Hall” or “Stereo” settings on the processor/amplifier.