OPERATIONS
STANDBY/ON Button | STANDBY/ | STANDBY/ON | BLANK |
(STANDBY/ON Indicator) |
| LASER | |
ON Button |
| ||
| VIDEO | RGB | |
|
|
|
| AUTO |
|
Power Switch |
| MENU | KEYSTONE |
|
|
| |
|
| MENU SELECT | |
| Zoom Knob | POSITION | RESET |
| FREEZE | PinP | |
|
| ||
| Focus Ring | MAGNIFY | MUTE |
| OFF |
| |
Lens cap
VOLUME
ENGLISH
Power ON
1.Check that the power cord is connected correctly.
2.Set the power switch to [ ]. The standby mode is selected, and the STANDBY/ON indicator is turned to orange.
3.Press the STANDBY/ON button 
on the control panel or the remote control transmitter.
4.The STANDBY/ON indicator ceases blinking and turns to green when power is on. Remove the lens cap.
5.Adjust picture size using the Zoom Knob.
6.Adjust focus using the Focus Ring .
Power OFF
1.Press the STANDBY/ON button 
on the control panel or the remote controller. Then,the message "Power off?" will appear on the screen, and the message will disappear by any operation
or no operation for 5 seconds. During this message indication, press the STANDBY/ON 
button again. The projector lamp is extinguished and lamp cooling begins. The STANDBY/ON
indicator blinks orange during lamp cooling. Pressing the STANDBY/ON button 
has no effect while the STANDBY/ON indicator is blinking.
2.The system assumes the Standby mode when cooling is complete, and the STANDBY/ON indicator ceases blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O].
3.The STANDBY/ON indicator is extinguished when power is off. Attach the lens cap.
Put the Lens cap to the lens properly. In order to do it, keep pushing two knobs on the lens cap, then fit it to the lens holding the cap in horizontal position.
WARNING • Please read this manual, and the separate “SAFETY INSTRUCTIONS” thoroughly before using the equipment. Always ensure that
the equipment is used safely.
NOTE • Except in emergencies, follow the
•To prevent any troble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a