Hitachi 42HDM12A important safety instructions Reception Problems

RECEPTION PROBLEMS

• IGNITION NOISE:

Black spots or horizontal streaks may appear, picture may flutter or drift. Usually caused by interference from automobile ignition systems, neon lamps, electrical drills, and other electrical appliances.

		English
	• GHOSTS:
	Ghosts are caused by the monitor signal following two paths. One is the direct path
	and the other is reflected from tall buildings, hills or some other objects. Changing
	the direction or position of the antenna may improve reception. Ghosting may also	Français
	• SNOW:
	be caused by defects in the antenna system such as unshielded leads or connecting
	several sets to the same antenna without using multiple antenna couplers.
	If your receiver is located in the fringe area of a television station where the signal is
	weak, your picture may be marred by the appearance of small dots. When the signal
	is extremely weak, it may be necessary to install a special antenna to improve the
	picture.
	• RADIO FREQUENCY INTERFERENCE:
	The interference produces moving ripples or diagonal streaks, and in some cases,
	causes loss of contrast in the picture.
	• PREVENTION OF AN OBSTACLE TO RADIO RECEIVERS
	This monitor has been designed pursuant to the FCC class B Rules. This is to
	prevent a problem to Radio receivers. If this monitor causes a problem to Radio
	receivers, then take the following steps:
	- Keep the monitor away from Radio.
	- Adjust Radio antennas in order for the monitor not to receive interference.
	- The antenna cable of Radio should be kept away from the monitor.
	- Use a coaxial cable for antenna.
	You can check if this monitor influences Radio receivers by turning off all other
	equipment other than the monitor.
	If you find a problem receiving Radio when using the monitor, check the instructions
	mentioned above.
• The display image appears	• Adjust the horizontal clock and clock phase.
scrolling diagonal.	(Adjust the horizontal clock first, the clock phase next.)
• Text displayed across the screen	(RGB input)
appears vertically streaked, with
the characters in vertical columns
blurred.
• Text displayed across the	• Adjust the clock phase for the clearest viewing.
screen appears blurred.	(RGB input)
• A fine pattern flickers when
displayed on the screen.
• Vertical stripes appear, depending on the	• The plasma display panel is lighting the phosphors by the discharge of internal
screen contents.	radiation. Depending on the screen contents, in rare cases this may cause vertical
	stripes to appear because of failure to light. Please note that this is not a
	malfunction.
• Coarse horizontal stripes appear in FULL	• Adjusting the clock phase will reduce the horizontal stripes.
display.	(RGB input)
• The display dims to make the picture invisible	• This condition may occur when the unit is connected to a VCR with component
during special playback of a VCR (FF, REW).	output, such as 480i, but it is not a failure. But when it occurs, switch to composite
	output.

31