JBL SCS200.6/230, SCS200.5/230 manual Wall-Mounting

WALL-MOUNTING
		Step 5: Tighten the Metal Nut
4		¡ with the star washer side
3	2	between the Metal Nut ¡
		and the back of the Satellite
		Speaker ¶, using large
	1	needle-nose pliers until it is
		firmly seated against the
		back of the Speaker ¶ and
8		has locked the Ball and
		Shaft £ and the Speaker ¶
5
		together.
		Note that once the Metal
Important Safety Note: The	Step 3: Slide the Molded Nut	Nut ¡ is fully tightened, it
customer is solely responsi-	™ onto the Ball and Shaft	may embed some marks on
ble for proper selection of	£ with the threaded open-	the back of the Satellite
mounting hardware not	ing facing the ball. Thread	Speaker ¶. However, these
included with the speakers,	the Metal Nut ¡ all the way	marks will be covered by the
and for proper assembly and	onto the Ball and Shaft £,	Metal Nut ¡.
installation of the wall-brack-	with the star washer side	Step 6: Mount the Attach-
ets, including but not limited	away from the ball. Refer to	ment Plate ¢ into a wood
to the selection of appropri-	the exploded drawing for the	stud on the wall, using four
ate weight-bearing supports	proper orientation of these	#10 pan-head wood screws
and proper use of the	three parts.	at least one inch long (not
bracket. JBL disclaims any		supplied) •.
liability for the selection of
mounting hardware and/or
bracket installation. Be sure	7
to follow these bracket
assembly and installation
instructions carefully. If you	6
have any questions or	1	2
doubts about your ability to
			4
correctly wall-mount the		3
speakers, consult with your
authorized JBL dealer or
custom installer.	5
Step 1: Unscrew and remove
		8
the large Molded Nut ™. If
necessary, use the supplied		Make sure that all four
Metal Bar ∞ as a lever by	Step 4: Screw the Ball and
inserting it into one of the	Shaft £ into the Threaded	screws are driven into the
holes in the outer edge of the	Insert § on the back of the	stud and not into drywall.
Molded Nut ™.	Satellite Speaker ¶ until	If the bracket needs to be
Step 2: Firmly grasp the Ball	it is fully seated in the	mounted in drywall, the
and Shaft £ and pull it	Threaded Insert §, but do	customer is responsible for
straight out of the Attach-	not tighten as you might dis-	selecting and using appro-
ment Plate ¢. Avoid leaning	lodge the Threaded Insert	priate wall-anchors and
it to the side for leverage, as	§. Such damage would	screws.
this may break off a tab.	not be covered under the	Important Note: The Metal
	warranty.
		Nut ¡ must be fully tight-

ened against the Satellite

7