JBL manual Installation, Rear of HTI88, Tools Needed

Connection Method #2, Using One HTI88 in Stereo Mode (Remove Shorting Straps)

Receiver/Processor	Amplifier
Subwoofer or	Line-Level Speaker-Level
Main Amp	Inputs	Outputs
Out		–	+
Left	Left		Left
		–	+
Right	Right		Right

	Rear of HTI88**
	BLK
+ IN 1	GRN
–		L 2
	L 1
	C 1
J 2 J 1	HTi88s
	C 3
	L 3	L 4
+
	BLK
IN 2 –
	ORN

+ OUT 1 –

C 2

C 4

+ OUT 2 –

** Use corresponding inputs on HTI88BB connections panel when installed with back box.

Connection Method #2, Using Two HTI88 Loudspeakers

With Back Boxes (Use Shorting Straps)

Receiver/Processor Amplifier

Subwoofer or	Line-Level Speaker-Level
Main Amp	Inputs	Outputs
Out		–	+
Left	Left		Left
		–	+
Right	Right		Right

		Left HTI88 Back Box***
YEL/BLK	YEL	WHT/BLK	WHT	ORG/BLK	ORG	GRE/BLK	GRE
–	+	–	+	–	+	–	+
INPUT 1		INPUT 2		OUTPUT 1		OUTPUT 2
		Right HTI88 Back Box**
YEL/BLK	YEL	WHT/BLK	WHT	ORG/BLK	ORG	GRE/BLK	GRE
–	+	–	+	–	+	–	+
INPUT 1		INPUT 2		OUTPUT 1		OUTPUT 2

*** Use corresponding inputs on rear of HTI88 speaker when installed without back box.

INSTALLATION

The JBL HTI Series in-wall speakers were designed to be easily installed. However, if you are unsure of your ability to properly install these loud- speakers, please contact your dealer or a qualified installer.

Tools Needed

Pencil Phillips-head #2 screwdriver

Measuring tape Utility knife

Awl

Carpenter’s level

7