 Troubleshooting, 125, Indicator Messages

9. Appendix

Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.

Indicator Messages

Power Indicator

	Indicator Condition			Projector Condition	Note
		Off		The main power is off	–
Blinking light	Green		0.5 sec On,	The projector is getting ready to turn on.	Wait for a moment.
			0.5 sec Off
			2.5 sec On,	Off Timer (Off Time) is activated.	–
			0.5 sec Off
	Orange		0.5 sec On,	The projector is cooling down.	Wait for a moment.
			0.5 sec Off
Steady light	Green			The projector is turned on.	–

	Orange			The projector is in Standby.	–

Status Indicator

	Indicator Condition			Projector Condition	Note
		Off		Normal	–
Blinking light		Red	1 cycle (0.5 sec On,	Lamp cover error	Reattach the lamp cover correctly.
			2.5 sec Off)		(→ page 120)
			2 cycle (0.5 sec On,	Temperature error	The projector is overheated. Move
			0.5 sec Of)		the projector to a cooler location.
			4 cycle (0.5 sec On,	Fan error	Fans will not work correctly.
			0.5 sec Off)
			6 cycle (0.5 sec On,	Lamp error	Lamp fails to light. Wait a full
			0.5 sec Off)		minute and then turn on again.
		Green		Re-firing the lamp	The projector is re-firing.
		Orange	1 cycle (0.5 sec On,	Network conflict	Both the built-in wired LAN and the
.		.	2.5 sec Off)	.	wireless LAN cannot be connected to
		.		.	the same network at the same time.
.		.		.	To use both built-in wired LAN and
.		.		.	wireless LAN at the same time, con-
.		.		.	nect them to different networks.
.					(→ page 102, 103)
Steady light		Orange		Control Panel Lock is on	You have pressed cabinet button
					when Control Panel Lock is on.
					(→ page 94)

		Green		The projector is in Standby.	–
Lamp Indicator

	Indicator Condition		Projector Condition	Note
		Off	Normal	–
Blinking light		Red	Lamp has reached its end of life. Lamp	Replace the lamp.
			replacement message will be displayed.	(→ page 118)

Steady light		Red	Lamp has been used beyond its limit.	Replace the lamp.
			The projector will not turn on until the	(→ page 118)
			lamp is replaced.

		Green	Lamp is in Eco mode	–

Over-Temperature Protection

If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lamp with the STATUS indicator blinking (2-cycle On and Off.)

Should this happen, do the following:

•Unplug the power cable after the cooling fans stop.

•Move the projector to a cooler location if the room where you are presenting is particularly too warm.

•Clean the ventilation holes if they are clogged with dust.

•Wait about 60 minutes until the inside of the projector becomes cool enough.

9. Appendix