NEC VT470 manual Audio Equipment

2. Installation and Connections

Connecting Your DVD Player with Component Output

VT676/VT670/VT575/VT470VT47

COMPUTER 1 IN AUDIO COMPUTER IN

VIDEO IN L/MONO AUDIO R COMPUTER 1 IN AUDIO COMPUTER 2 IN

S-VIDEO IN	L/MONO AUDIO	R	AUDIO OUT	PC CONTROL
				MONITOR OUT
				AC IN

VIDEO IN L/MONO AUDIO R	AUDIO	COMPUTER IN
S-VIDEO IN		PC CONTROL

Optional 15-pin - to - RCA (female) ×3 cable (ADP-CV1)

Component video RCA×3 cable (not supplied)

Y Cb Cr

Component

	Audio Equipment
DVD player
L R
AUDIO OUT	AUDIO IN
	L R

Audio cable (not supplied)

You can connect your projector to a DVD player with component output or Video output. To do so, simply:

1.Turn off the power to your projector and DVD player.

2.If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component video cable (RCA×3) and the optional 15-pin-to-RCA (female)×3 cable to connect your DVD player to the COMPUTER IN connector on the projector.

For a DVD player without component video (Y,Cb,Cr) output, use common RCA cables (not provided) to connect a composite VIDEO output of the DVD player to the Video Input of the projector.

3.Connect the supplied power cable. See page 20.

4.Turn on the projector and DVD player.

A component signal will be automatically displayed. If not, from the menu, select [Advanced] → [Signal Select] → [Computer], and then place a check mark in the Component radio button.

NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.

18