Troubleshooting
If there is no sound from any of the speakers, check the following:
•Make sure the subwoofer is plugged into an active AC wall outlet.
•Make sure the Master Power Switch, located on the rear of the subwoofer, is in the “On/Standby” position.
•Make sure there is a source – for example, a VCR or television – hooked up to the TV or tape/aux input jacks on The Source.
•Make sure that the program material is playing.
•Recheck the hookup connec- tions.
If most of the sound comes from the
Although most of today’s televi- sions are equipped with stereo audio output jacks, some stereo televisions have poor audio sec- tions and are unable to provide a Dolby Pro Logic encoded signal. In the unlikely event that you experi-
ence this problem, connecting the audio outputs from your
If there is no sound from the surround speakers or sound is very low, check the following:
•Check all connections between the amplifier and each of the speakers.
•Raise the surround volume from the remote control (see “Operation” section).
•Make sure the TV show or movie you are watching is recorded in Dolby Surround.
If there is no sound from the center speaker, check the following:
•Make sure that the processor is in the Pro Logic mode. If it is in Phantom or Stereo mode, the center speaker will not play.
•Check the connections between the subwoofer and the center speaker.
If you have low bass output, check the following:
•Experiment with placement of the subwoofer. Remember, place the subwoofer in a corner to get maximum bass output from the system.
•Increase the level of bass, using the remote control.
•Adjust the level control on the rear of the subwoofer.
If you are having trouble picking up radio stations, check the following:
•Make sure the antenna is hooked up properly.
•Depending on your distance from the station’s transmitter, you may need to install an FM antenna on the roof or in the attic.
– 18 –