The Procedure Up to Projecting to the Screen
Perform setup adjustments in the following order.
1 Position the projector
Determine the locations to set up the screen and the projector.
See “Placement Guide” on Page
2 Connect the video equipment and personal computer
Connect your equipment to the projector.
When making connections with the personal computer’s DVI connector or RGB connector, see “Connections with Personal Computers” on Page
When making connections with the video equipment’s video connector or an
When making connections with the video equipment’s YCbCr connector or YPbPr connector, see “Connections with Component Signals” on Page
When playing the audio through the
Monitoring the analog RGB input signal, see “Connections with the RGB OUT Connector” on Page
3 Opening the lens shutter or lens cap
4 Connecting the power cable and switching on the power
See “Operating” on Page
See “Finishing” on Page
5
6
7
8
9
When selecting the language of menu displays, etc.
(Only when the power is first switched on following purchase)
See “When [Menu Language Select] Is Displayed Upon Switching On the Power” on Page
Switching on the power of the personal computer and video equipment
Properly adjust the projection image to the screen
See “Adjustment of the Projection Screen” on Page
Selecting input equipment
See “Input Selection” on Page
Adjust the screen or video image
Adjust the image to the optimum condition as required.
See the Table of Contents for the adjustment items.
About DLP projectors
Though careful attention is paid to providing optimum quality, please note that with DLP type projectors, in rare cases there may be black spots or bright spots among the picture elements.
Note:
*Please purchase a screen.
*A
*A component cable (order code
*A component cable (order code