Philips FWV785, FWV780 manual General Information, Environmental Information, Supplied accessories

Page 7

General Information

IMPORTANT!

PLEASE NOTE THAT THE VOLTAGE SELECTOR LOCATED AT THE REAR OF THIS SYSTEM IS PRESET AT 220V FROM THE FACTORY. FOR COUNTRIES THAT OPERATE AT 110V-127V, PLEASE ADJUST TO 110V-127V BEFORE YOU SWITCH ON THE SYSTEM.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialised company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Supplied accessories

Remote control

Batteries (two AA size) for remote control

AM loop antenna

FM wire antenna

AC power cord

One Video cinch cable

Safety Information

Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer.

Place the system on a flat, hard and stable surface.

Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.

When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

English

7

pg 001-032/V780&785/21-Eng

7

12/11/01, 5:15 PM 3139 115 21143

Image 7
Contents Audio Constantly improving performance Presenting Super Error CorrectionTape 12/11/01, 515 PM 3139 115 Index Contents Environmental Information Supplied accessoriesSafety Information General InformationLeft SpeakerRear Connections Front Speakers Remote ControlConnecting other equipment to your system Inserting batteries intoControls on the system and remote control Controls ≤ Display § ClocktimerReturn £ TITLE/ALBUM NameBasic Functions Demonstration modePlug and Play Power Saving Automatic Standby Switching the system onSwitching the system to Standby mode Switching the system to Eco Power Standby mode 1 WattSound Navigation Discs for Playback CD/VCD/MP3-CD OperationDisc Playback Loading DiscsReplace discs during playback Programming the disc tracks Select a desired track/passageNormal playback Title/Album NameRepeat To erase the entire programmePlaying a Video CD with PBC Adjusting the TV SystemSwitching off PBC OSD On Screen DisplayZoom Press digit 1 on the remote control to select Intro ScanReturn Repeat DigestKey Control I È ResumeSlow VocalRadio Reception Storing Preset Radio StationsRadio frequency remain on the display Tuning to Preset Radio StationsErasing a Preset Radio Station Changing Tuning GridTape Operation/Recording To change the playback modeTo rewind or fast forward when playback is stopped To reset tape counter numberCD/VCD/MP3-CD Synchro Recording When recording is in progressGeneral Information on Recording Preparation for RecordingTo stop dubbing KaraokeDubbing Tapes Microphone MixingTo exit without storing the setting Clock SettingTimer Setting Press Clocktimer twiceExternal Sources Clock/TimerTo deactivate the Timer To activate the Timer for the same presetSpecifications Disc Player Operation MaintenanceTroubleshooting Problem SolutionTape OPERATION/RECORDING Radio Reception3139 115 SL-0138/21-4 Meet Philips at the Internet