Fig. 19: Removing the second serial port
3. Take the second serial port out of the chassis and put it aside.
Removing the Switch/LED board
To remove the Switch/LED board, first remove the stabilisers (see Removing the Stabilisers), open the chassis (see Opening the Chassis), then follow the next steps:
1.Disconnect the cable from the Switch/LED board.
2.Remove one screw.
3.Carefully remove the Switch/LED board from the chassis and put it aside.
Fig. 20: Removing the Switch/LED board
Note: To remove also the cable of the Switch/LED board, the IDE cables must be disconnected from the motherboard, as they cover the cable of the Switch/LED. In order to easily reach the IDE cables it is better to first remove the floppy disk drive (see Removing the Floppy Disk Drive).
Removing the Internal Speaker
To remove the internal speaker, first remove the stabilisers (see Removing the Stabilisers), open the chassis (see Opening the Chassis), then follow the next steps:
1. Remove the screws and the connector shown in the picture
X2
X1
NEC PowerMate ML5 Disassembly Manual | Page 13 |