Philips FWP3200D user manual Get started, Connect power, Prepare the remote control, Serial No

Page 11

3 Get started

Caution

Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

Always follow the instructions in this chapter in

If you contact Philips, you will be asked for the model and serial number of this apparatus.The model number and serial number are on the back of the apparatus.Write the numbers here: Model No. __________________________

Serial No. ___________________________

Connect power

Caution

Risk of product damage! Make sure that the power supply voltage corresponds to the voltage printed on the head of the AC power cord.

Risk of electric shock! When you unplug the power cord, always pull the plug from the socket. Never pull the cord.

Note

Before you connect the AC power cord, make sure that you have completed all other connections.

Prepare the remote control

1 Press and push the battery compartment to slide it open (see "1" in the illustration).

2 Insert two AAA batteries with correct polarity (+/-) as indicated.

3Push and slide back the battery compartment (see "3" in the illustration).

Connect the AC power cord to

the ~ AC IN socket on this unit. the wall power socket.

Note

The batteries shall not be exposed to excessive heat

If you are not going to use the remote control for a long time, remove the batteries.

Do not mix batteries (old and new or carbon and alkaline, etc.).

Batteries contain chemical substances, so they should be disposed of properly.

12EN

Image 11
Contents Register your product and get support at Contents Produce heat SafetyKnow these safety symbols Important Safety InstructionsDistortion Hearing safetyListen at a moderate volume Mains fuseHuman health Be careful not to adjust the volume as your hearing adaptsHazard and is illegal in many areas Human health This product complies with the radio CommunityPage Congratulations on your purchase, Your Mini Hi-Fi SystemIntroduction Whats in the boxMicrophones Overview of the main unitMIC 1/MIC MIC VOL Connect microphones Switch headphone output between audio source a and B Overview of the remote control Always follow the instructions in this chapter Connect powerPrepare the remote control Get startedBasic play operations Switch to standby modePlay Turn onCharge the iPod/iPhone Compatible iPod/iPhoneListen to the iPod/iPhone Load the iPod/iPhoneListen through headphone Play from USBPlay options Tip Select a preset radio stationSelect a sound effect Adjust soundAdjust speaker volume Select an audio output modeSpeak or sing through the Hi- Fi system Play audio from an external deviceMusic beat Off Adjust decoration lightEnjoy simultaneous play On the back panel of the unitGeneral information Product informationUSB playability information SpeakersPosition Troubleshooting