Safety and Warranty Information

Safety Information

•Always follow all warnings and instructions marked on the product.

•Use only the power source indicated on the product regulatory label.

•Use only the power cord that comes with the product. Using another power cord may cause fires and or shock. Do not use the included power cord with any other equipment.

•If you do not use this product for a long period of time, unplug it from the electrical outlet.

•Always turn this product off by using the On/Off button. Wait until the On/Off button stops flashing before removing the power plug from the outlet.

•Do not allow the power cord to become damaged or frayed.

•If you need to use an extension cord with this product, make sure that the ampere rating of the product does not exceed the ampere rating of the extension cord.

•Place the product on a flat, stable surface that extends beyond the product’s base in all directions. This product will not operate properly if tilted or at an angle.

•When storing or transporting this product, do not tilt or stand it on its side. Never turn this product upside down (ink can leak out of the product).

•Avoid placing this product in an environment that is subject to rapid changes in temperature or humidity, mechanical shocks, vibration, or dust. Do not place near radiators, heating vents, or in direct sunlight.

•Leave enough room around this product for sufficient ventilation.

•Do not block this product’s covers or openings, or insert any objects through slots.

•Do not use aerosol products inside or around this product.

•Do not spill any liquid on this product.

•Do not attempt to repair or service this product.

•If the power cord or plug is damaged, if any liquid has been spilled onto the product, if the product has been dropped or the case damaged, if the product does not operate normally or exhibits

a major change in performance level, unplug this product and contact Kodak at www.kodak.com/go/contact.

LCD Screen Safety

•Use only a dry, soft cloth to clean the LCD screen. Do not use any liquid or chemical cleaners.

•If the LCD screen is damaged, contact Kodak immediately. If any of the solution from the display gets on your hands, wash them thoroughly with soap and water.

Ink Cartridge Safety

•Keep all ink cartridges out of the reach of children.

•If ink gets on your skin, wash with soap and water. If ink gets into your eyes, flush immediately with water. If any discomfort or change in vision persists after washing, seek medical attention immediately.

•For MSDS information on inks, go to www.kodak.com/go/MSDS.