Kodak 4800 manual Following table shows cartridge-related error messages

Page 63

Reference Guide

The following table shows cartridge-related error messages.

Error Message

Corrective Action

Unrecognized cartridge

Be sure the cartridge is the correct cartridge for

 

your printer model. Your printer will not work with

 

cartridges from other models. Remember, the

 

printer is reading the value programmed into the

 

chip on the cartridge. Replace the cartridge if

 

necessary.

 

 

Cartridge end of life attained.

Replace cartridge. You can check cartridge status

 

by choosing Cartridge Info from the Service menu.

 

Cartridge usage is displayed in milliliters (ml). The

 

cartridge is warranted for 500ml of ink throughput.

 

When 1280ml is displayed, no further printing

 

occurs until the cartridge is replaced.

 

 

Unrecognized ink type.

Be sure the cartridge is the correct cartridge for

 

your printer model. Your printer will not work with

 

cartridges from other models. Ink type information

 

is stored on the cartridge chip. If you are using a

 

new type of ink, which has been introduced since

 

you purchased your printer, you will need to

 

upgrade the printer's firmware to accommodate the

 

new ink type.

 

 

To clear the error, turn the printer off and then on again. Press Utility Menu/Service Menu/Cartridge Info to determine the cartridge for which the error message is dis- played. Press Utility Menu/Access Menu/Access Left or Access Right to move the carriage to the position which allows replacement of the ink cartridges. Check to make sure you have the correct cartridge for your printer model installed in each position, that they all contain the same type of ink and all cartridges are installed properly. Install new cartridges if necessary.

Error messages D-2

Page 62 Page 64
Image 63
Page 62 Page 64
Contents Reference Guide Warranty FCC Statement U.S.A VDE statement Industry CanadaVcci Japan Material safety data sheet General operating safetyPrinter Disposal Dryer safety Manual conventionsOther reference materials Contents Installing additional memory Printing with 4800 Series printers Introduction1Obtaining quality results Use the Correct Inks and MediaCaring for Media Operating Environment Caring for your ink and cartridgesUse the right software Choose the correct printing modeChoose the right media Caring for your mediaOriginal Image Type Nine Factors that Affect Print QualityScan Resolution Original Image Clarity and ColorScanner Type Post Scanning Color Correction and Sharpening RIP Diffusion/Dither Patterns RIP Color ProfileCartridge Preparation and Alignment Ink and MediaPrinter options Cartridge setTo choose the cartridge set DPI Choosing print mode optionsTo choose print quality Color modeTo choose the color mode Quality modesTo choose dpi Dots per inchTo set the carriage speed Print passesTo change the number of passes Carriage speedEnd of media Print directionTo change the print direction Choosing feed media optionsTo set end of media Media counterTo enter a media length value Choosing paper options To reset the media counterTo display the current value To print the current valueTo choose the media standard Supply TypeTo choose supply type Media standardMedia Sizes and Maximum Printing Areas for Rollfeed Media Media Sizes and Maximum Printing Areas for Sheet Media Cut sheet maximum printing area MarginsAuto-Cut Auto-Load DelayTo set auto-load delay To set marginsTo reset counter to zero and initiate Auto-Cut Auto-Cut DelayTo set Auto-Cut Delay Delay StatusTo turn off Save Media Defining user setupTo save user setup Save MediaChoosing ink options To use a previously saved user settingChoosing a language To choose a languageTo turn on the wiper Press Setup Menu/Paper Option Menu/Auto-WipeTo set the dryer LCD ContrastTo set LCD contrast Returning to the default settings Printing the settingsUser Settings Default Other Options Printer Default SettingsPrinting vector data Accessing HP-GL/2 featuresTo access HP-GL/2 features HP-GL/2 optionsPalette select To choose a palette typeControl Reprints To set controlRotation To rotate the imageInk reduction To set ink reductionNesting Nest wait time To enable nestingHP-GL/2 Test File To enable the ink limitTo define nesting wait time Ink limitTo remove the right cover Installing additional memoryDimm installation Acceptable Dimm sizesTo remove the Dimm To install the new DimmMedia Roll Parameters Technical informationTechnical information B-2 Main menu at a glance Menu treeMain menu L lFeed media menu L lEnglish, Metric Setup menu at a glanceSetup menu Print Mode Menu L l HP-GL/2 Menu User Setup Menu L l Utility menu at a glance 32.00 34.00 33.00 defaultUtility menu Calibration Menu Service Menu Error messages Error MessagesCartridge Errors Following table shows cartridge-related error messages TroubleshootingE Troubleshooting quick listIsolating problems Printer Health Be sure the paper feed option is set to Takeup Fore Performing this Step Cannot draw ink during initial siphon Ink cartridges do not fire properly Ink spills on the flex cable Overall print quality is poor Calibrate cartridges Steps to Minimize Ghosting Parasitic Suppression Perform color calibration. See the Quick Start Guide Data Transfer Troubleshooting E-13 Application Software Customer Technical Support Calling for Help
Related manuals
Manual 1 pages 28.68 Kb

4800 specifications

The Kodak 4800 is a significant addition to the world of digital photography, blending advanced technology with user-friendly features to capture stunning images. This camera is well-suited for both amateur photographers and seasoned professionals, catering to a wide range of photographic needs.

One of the standout features of the Kodak 4800 is its impressive resolution. With a powerful 48-megapixel sensor, users can achieve remarkable image clarity and detail, making it perfect for large prints and high-quality displays. The camera excels in various lighting conditions, thanks to its advanced ISO range, which allows for stunning low-light performance while minimizing noise.

The Kodak 4800 incorporates a versatile zoom lens, providing users with the flexibility to capture a variety of scenes, from expansive landscapes to close-up portraits. With optical zoom capabilities that offer a focal range suitable for multiple genres of photography, this camera is an all-in-one tool for budding and professional photographers alike.

In terms of technology, the Kodak 4800 features an intuitive touchscreen interface, making navigation straightforward and enjoyable. The menu system is designed to be user-centric, allowing quick access to essential settings and modes. This is complemented by built-in Wi-Fi and Bluetooth connectivity, which enables seamless sharing of images and remote control capabilities via smartphones.

Another hallmark of the Kodak 4800 is its robust video capabilities. The ability to record in 4K resolution allows for stunning footage that captures the action in vivid detail. Whether filming a family gathering or a professional event, users can rely on the camera’s comprehensive video features.

The Kodak 4800 also includes various shooting modes and filters, enabling users to experiment creatively. From stunning time-lapse sequences to slow-motion effects, the camera encourages exploration of different artistic expressions.

Battery life is another critical aspect of the Kodak 4800, with efficient power management ensuring users can shoot for extended periods without worry.

In conclusion, the Kodak 4800 stands out for its combination of high-resolution images, versatile zoom capabilities, user-friendly interface, strong video functionality, and innovative technologies. This camera appeals to a diverse audience, promising to enhance the photographic experience and inspire creativity.
Top Page Image Contents