Parts Included Tools Needed How to Unpack

Parts Included • Tools Needed • How to Unpack

We hope this manual will provide clear instructions to install and operate the MV-2222 and MV-1111. Two symbols have been used —

	!	Indicates caution should be taken!	Indicates suggestions to make
	!		processes easier for you.
PARTS INCLUDED:
1	Radome		2 Cable clamps
3 base mounting feet			1 Cable entry plate
1	Power switch		1 large yellow spade connector
1	Demultiplexer DC passive		2 small red spade connectors
1	Demultiplexer DC block (MV-2222 only)		All required screws and washers
2	Wall plates (white & brown)		1 base with electronics, dish, stacked LNBF
1	Surface mount bracket		1 tube silicone

7/16” open end wrench Level

Drill w/3/4” bit

1-1/4” hole saw (if mounting switch in wall) 5/16” Socket for roof screws

1/8” Allen wrench

1. Open box and remove packing material.

If using knife to open

!carton, BE CAREFUL. Do not cut the dome on the unit.

2.Lift unit out of box vertically. Do not turn box and “roll” out, or turn upside down to remove.

1/2” Open end wrench

Crimping tool for coax connections Crimping tool for electrical connections Small blade screw driver

Pliers

Sealant (consult RV manufacturer for proper type for your roof material)

LIFT UNIT STRAIGHT UP

USE 2 PEOPLE

when removing the unit from the carton.