NEC M700 user manual Quick Start, Figure A.1

Quick Start

To attach the MultiSync® M700™ monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.If necessary, install the display card into your system. For more information, refer to the display card manual.

3.For the PC: Connect the MultiSync M700 15-pin mini D-SUB of the captive combined signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

Captive Combined

Signal Cable

15-pin mini D-SUB

Figure A.1

For the Mac: Connect the Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the captive combined signal cable to the Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the MultiSync M700 cable adapter, call

NEC Technologies at (800) 820-1230.

Captive Combined

Signal Cable

Computer	Mac Adapter
	(Not included)
Figure B.1	15-pin mini D-SUB

3

15500291.wpc 5 7/27/99, 3:41 PM