NEC LCD175VXM+ user manual Raise and Lower Monitor Screen, Tilt, English-4

3.To attach the Cable management cover:

Insert the tabs of the Cable management cover into the holes of Stand neck and slide the Cable management cover downward into place (Figure A.4).

NOTE: Please confirm that the tabs are completely secure.

4.Connect all cables to the appropriate connector on the back of the monitor (Figure B.1). Connect the Headphone (not included) to the appropriate connector at the rear side of the monitor (Figure C.1).

5.Connect one end of the power cord to the monitor and the other end to the power outlet. Place the Video Signal Cable, Audio cable and power cord to the Cable management cover (Figure B.1).

Stand

Base

Cable management cover

NOTE: Adjust position of cable that place under the Cable management cover to avoid damage for cable or monitor.

NOTE: Please refer to Caution section of this manual for proper selection of power cord.

6. Turn on the monitor with the front power button and the computer (Figure C.1).

AUDIO INPUT

DVI-D (Input2)

D-Sub (Input1)

Cable management cover

Connect to

Computer audio output

Figure A.4

Power Button

Figure B.1 Figure C.1

7.No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings. For further adjustments, use the following OSM controls:

¥Auto Adjust Contrast

¥Auto Adjust

Refer to the Controls section of this UserÕs Manual for a full description of these OSM controls.

NOTE: If you have any problem, please refer to the Troubleshooting section of this UserÕs Manual.

Raise and Lower Monitor Screen

The monitor may be raised or lowered. To raise or lower screen, place hands on each side of the monitor and lift or lower to the desired height (Figure RL.1).

NOTE: Handle with care when raising or lowering the monitor screen.

Figure RL.1

Tilt

Grasp both sides of the monitor screen with your hands and adjust the tilt as desired (Figure TS.1).

Figure TS.1

English-4