Lexmark 258x, 259x manual DC1

Draft document

2-2

Control Codes

Table 2-1: Control Codes (Continued)

			Value	Value
Code Name	Symbol	Description	(Dec)	(Hex)
		Sounds the printer beeper for approximately 1
Beeper	BEL	second.	7	07
Vertical Tab	VT	Advances the paper to the next vertical tab position set	11	0B
		by the ESC B command. If no tab position is set, the
		printer performs a single line feed.
		If the next vertical tab position is greater than the form
		length (or form length minus skip perforation), the VT
		does a line feed.
		An automatic carriage return may be optionally disabled
Form Feed	FF	Advances the paper to the top of the next page and does	12	0C
		a carriage return.
Carriage Return	CR	Moves the current print position to the left margin of the	13	0D
		current line. An automatic line feed may be optionally
		added by the setup.
Double-Wide Printing by	SO	Prints all characters in double-width mode.	14	0E
Line		This mode is canceled by the receipt of ESC [ @, ESC W
		n, CR, LF, VT, FF, DC4, CAN or auto wrap.
Condensed Printing	SI	Condenses printing from 10 characters per inch (cpi) to	15	0F
		17.1 and 12 cpi to 20.
Select Printer	DC1	Selects the printer, causing all subsequent data to be	17	11
		accepted.
Select 10 cpi	DC2	Returns condensed printing to normal (10 cpi). Cancels	18	12
		SI mode.
Deselect Printer	DC3	This control code has no effect on the parallel interface.	19	13
		This command is accepted and ignored.
Cancel Double-Wide	DC4	Cancels double-width printing mode and returns printing	20	14
Printing by Line		to normal.
Cancel Data	CAN	Clears current line buffer of data already received to print	24	18
		on the current line. Does not change the current print
		position