Fluke MedTester 5000C installation instructions INSTALL port baud Enter

M E D T E S T E R 5 0 0 0 C F I E L D U P G R A D E I N S T A L L A T I O N I N S T R U C T I O N S

6.Run the computer in DOS mode (command prompt).

Note

If running Windows 95 or 98, with the mouse you can click and hold the Start button, then select Programs and MS-DOS Prompt.

If running Windows 2000 or XP, with the mouse click the Start button, select Programs, Accessories, and Comnmand Prompt.

7.Insert the diskette into the computer's 3.5" floppy disk drive.

8.At the DOS prompt type this command:

A:\INSTALL port baud <Enter>

Where A is the floppy disk drive letter, A or B, and port is the computer COM port, 1 through 4, and

baud is the selected baud rate: 300, 600, 1200, 2400, 4800, 9600, or 19200.

Here’s an example of this command:

A:\INSTALL 1 9600<Enter>

9.The program will install (enable) the module in the medTester. The computer should display MODULES SUCCESSFULLY LOADED. Note: If you have problems or get a different message, you can read the README file by typing A:README<Enter> for suggestions. Modules are customized for each instrument and can only be installed on the instrument with that specific serial number. Some modules need prerequisite modules to be installed first.

MODULE PREREQUISITE REQUIREMENTS

Module	Description	Prerequisite
2	RS232 / Printer	None
3	100 Record Storage	Module 2
4	Expanded Record Storage	Modules 2 & 3
5	Waveforms / Extended Testing	Modules 2 & 3
6	Data Transfer	Modules 2 & 3
7	MedCheck	Modules 2, 3, & 4
8	DEFIB Autosequences	Modules 2,3, & 4
9	IVPUMP Autosequences	Modules 2,3, & 4
10	Competitive CMMS Interface	Modules 2,3,4,6 &
		7
11	ESU Autosequences	Modules 2,3, & 4
12	SPO2 Autosequences	Modules 2,3, & 4
13	PACER Autosequences	Modules 2,3, & 4
14	NIBP Autosequences	Modules 2,3, & 4

9