Emerson 185 Controller, Table C. Time Delay Settings, Table D. Voltage and Frequency Settings

Series 185	CONTROLLER (continued)
S1 DIP switch	S2 DIP switch	S3 DIP switch

Figure 6. DIP switches S1 and S2 at the top right.

The time delay settings are shown in Figures 6 and 7 and
in Table C. The sensor settings are shown in Figure 6
and in Table D. The standard (factory) settings are
shown in Tables C, D, and H.				Figure 7. DIP switch S3 at the bottom center.
		Table C. Time Delay Settings
Time Delay Description		Factory Setting	Settings		DIP Switch		DIP Actuator	Actuator Position
override momentary		3 seconds	1 second		S2	1		on (up)
utility outages			3 seconds		S2	1		off (down)
transfer to generator		10 seconds (approx.)	–		–		–	–
override momentary		4 seconds	4 second		S3	9		on (up)
generator outages			0		S3	9		off (down)
transfer to utility		5 minutes (approx.)	–		–		–	–
unloaded running		2 minutes	2 minutes		S1	10		on (up)
(generator cooldown)
			5 minutes		S1	10		off (down)
			0 seconds		S3	7, 8		both on (up)
load disconnect delay
		0 seconds	3 seconds		S3	7, 8		7 on (up), 8 off (down)
before transfer (and delay
			10 seconds		S3	7, 8		7 off (down), 8 on (up)
after transfer, if enabled)
			20 seconds		S3	7, 8		both off (down)
		Table D. Voltage and Frequency Settings
Setting Description	Setting	Factory Setting	Settings		DIP Switch		DIP Actuator	Actuator Position
voltage	–	220 – 240 V	non–adjustable		S2		2	on (up)
frequency	nominal	60 Hz	50 Hz		S1		4	on (up)
			60 Hz		S1		4	off (down)
phase	–	single	non–adjustable		S1		6	on (up)
	pickup	198 V	198 V		S1		3	on (up)
			209 V *		S1		3	off (down)
			198 V *		S1		1	off (down)
					S1		2	off (down)
utility voltage			187 V		S1		1	on (up)
	dropout	187 V			S1		2	off (down)
			176 V		S1		1	off (down)
					S1		2	on (up)
			154 V		S1		1	on (up)
					S1		2	on (up)
generator voltage	pickup	198 V	non–adjustable		–		–	–
	dropout	165 V
generator frequency	pickup	57 Hz (nom 60 Hz)
		48 Hz (nom 50 Hz)
			non–adjustable		–		–	–
	dropout	51 Hz (nom 60 Hz)
		43 Hz (nom 50 Hz)

* If the dropout voltage is set to 198 V, the pickup voltage must be set to 209 V.

381333–319 E 4