TOC 
INDEX
7. Place the leading edge of label stock under the "label stock" symbols on the Throat Guides.
The label stock should be placed far enough into the throat of the printer to correctly position the Movable Throat Guide but not yet into the printer itself. The label stock should be biased against the Fixed Throat Guide.
8.Slide the Movable Throat Guide inward until it almost touches the label stock. There must be slightly more space between the Throat Guides than the width of the label stock. If the label stock is pinched by the guides, poor print quality or even feeding problems could result.
5. Place label stock on Roll Arm.
8. Slide Throat Guide inward until it almost touches the label stock.
7.Place the leading edge of the label stock just past the Throat Guides, but not into the printer itself.
6 Slide Roll Guide assembly inward.
9.Feed the label stock further into the printer until it senses the label and automatically feeds it through the printer.
9.Feed the label stock further into the printer until it senses the label and automatically feeds it through the printer. If the printer fails to feed the label stock, press the Feed button on the front panel while continuing to guide the label stock into the printer. The printer can sense through- hole stock as well. If you are using label stock that has a hole punch to identify a transition from backing to label, you can adjust the Sensor Position Adjust tab to position it
Supplies and Driver Settings 11