Philips 5.1 manual Pdif Enable

Philips Sound Solutions

Figure 15

Before you start recording, you need to configure the recording source. Select a source by clicking the appropriate “Select” button. Each source has its own level and balance controls. To set each slider in its default position, right click on the sliders. See Figure 15.

The default recording source is Input Mix, but you can select other sources by going to the Mixer tab and clicking on the Recording sub-tab.

3.3.4.3.Advanced Mixer Sub-Tab

S/PDIF Enable

The S/PDIF digital output normally supplies the digital equivalent of the signal present at the analog (front speakers or headphones) outputs. However, when this button is selected, Dolby Digital (AC3) or DTS audio from DVD playback is passed through to the RCA S/PDIF output for external decoding. See Figure 16.

NOTE: For proper AC3/DTS pass-thru operation, the software DVD player application used may require additional configuration settings. Refer to the DVD player documentation for additional instructions.

Figure 16

The Ultimate Edge™ Soundcard Users Guide 22