Philips 62PL9524, 55PL9524 setup guide Operating Accessory Devices with the TV Remote

Operating Accessory Devices with the TV Remote

Once you have programmed your TV remote, refer to page 27 to see how the remote func- tions with accessory devices.

Before the remote will operate an accessory device, you must select the correct mode: CBL (cable box), VCR, DVD, SAT (satellite), or AMP (amplifier).

1 Press the Select button to cycle through the accessory modes. When the mode you want lights up, stop pressing the button. After a few seconds, the light will begin blinking. The blinking means that the remote is in the acces- sory mode you have selected.

NOTE: The remote is in accessory mode as long as the light keeps blink- ing. If you do not use the remote for 60 seconds the light will switch off, and the TV will go back to TV mode. The 60-second timer restarts each time you use the remote in an accessory mode.

2 Point the front of the remote toward the front of the accessory device, then press the button to perform the desired function.

HELPFUL HINT

●Press the Select button once to return the remote to the TV mode.

●Press the Select Button twice to select another device by cycling through the accessory mode choices.

cCHECK IT OUT

You can change the duration of the time-out mode by simultaneously pressing the Select button and a digit button, 1–4. Using digit 1 will set the time-out to 15 seconds; digit 2, 30 seconds; digit 3, 60 seconds; and digit 4, 120 seconds. The default time-out setting after you replace the batteries in the remote is 60 seconds. All modes will have the same time- out setting.

GUIDE

POWER SELECT POWER

INFO

HIGH DEFINITION

INFO	SELECT	DNM
CC	SURR	HD
1SURF		SCREEN
		FORMAT

PIP

P

AV+

	ACTIVE	SLEEP
SAP	CONTROL	TIMER	CLOCK
AUTO			AUTO

26

Point the front of the remote

2 toward the front of the accessory device, then press the necessary buttons to per- form the functions you desire. Refer to pages 27 to see the functions of the but- tons in the respective acces- sory modes.

To backlight the remote control but-

tons, press and hold the Select button for

two seconds. If you do not press any remote buttons for five sec- onds, the backlight switches off.

Each time you press a remote but- ton while the backlight is on, the five-second time-out function is reset. After the backlight switches off, you must press and hold the Select button for two seconds to turn it back on.