Philips CRA01/00 manual

Page 4

4.Remove the SmartCard slot cap from the display by removing the two screws circled below. Keep the screws for use in step 8.

5.Remove the hex nuts from the high-rise 15-pin D-SUB connectors as shown below with a 5mm nut driver tool. Keep the hex nuts for use in step 6.

high-rise DB 15 connectors

6.Place the LT card cap over the LT card as shown below. Secure the card cap by re-fastening the hex nuts onto the high-rise 15-pin D-SUB connectors.

Page 4 of 9

LT Installation Guide 1.1 (140907)

 

12NC: 3139 125 39281

Image 4
Contents Loop-Through Card Installation Guide Brief Electrical Specifications Package ContentsIntroduction Installation Instructions Loop-Through Card I/O InterfacesPage Page Connection Instructions Troubleshooting RS232 doesn’t seem to work properly via the LT card LT Card CRA01/00 Installation Guide