Samsung SW-208 manual Connecting the Cables, Board, Connecting the IDE cable

Connecting the Cables

1. Power cable

2. Master/slave select terminal

●You already have an additional IDE device installed in your computer.

Second IDE cable First IDE cable

3. IDE cable

4. Audio cable

1 Connecting the power cable

The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the CD-R/RW drive.

CD-R/RW CD-ROM

(MA) (SL)

Mother

board

Hard disk	Hard disk
(SL)	(MA)

2 Installing a jumper on the master/slave select terminal

Install the jumper in the correct position on the terminal:

MA to use the device in the master mode

SL to use the device in the slave mode CS to control the device via a CSEL

host interface signal

See Step 3 for further details.

3 Connecting the IDE cable

Two configurations are possible.

●The CD-R/RW drive is the only IDE device in addition to the hard disk.

IDE port

Mother board

CD-R/RW Hard disk

(SL) (MA)

Install the jumper in the SL position (Slave).

Connect the 40-pin flat IDE cable from the IDE port on the mother board, first to the CD-R/RW drive and then to the hard disk.

Install the jumper in the MA position (Master).

Connect the 40-pin flat IDE cable from a second IDE port on the mother board directly to the CD-R/RW drive or first to another additional IDE drive and then to the CD-R/RW drive.

4 Connecting the audio cable from a sound card

Connect the 4-pin audio cable between the sound output terminal on the CD-R/RW drive and the audio input terminal on the sound card.

6 7