Philips LC5141 manual Adjusting the focus of the image, Projection angle, Skew correction

Page 9
Keystoned image

6. Set Up

4.To switch off the mains supply completely, pull the mains plug out of the wall socket.

Note: Before disconnecting the power cord, make sure that the

cooling fan has stopped (about 3 minutes after the projector has been switched to Standby).

Adjusting the focus of the image

Use the Focus ring to adjust the focus of the image.

Focus ring

Adjusting height and level of the projector

Use the Height/Level Adjuster to adjust the vertical angle of the projector as specified under ‘Positioning the projector and screen’.

Projection angle

Press the adjuster button on the top cover of the projector.

Lift the projector to allow the adjuster leg to drop into position.

Release the button. The extended adjuster legs will be locked.

Skew correction

Turn the rear adjuster either clock-wise or counterclockwise to accurately adjust the skew.

Use the Focus ring to readjust the focus of the image.

Vertical keystone correction

If projector and screen are not properly placed, the picture will be distorted, producing a

keystone image. Vertical keystone correction allows you to correct picture distortion of the vertical keystone type by internal scaling. By pressing the D-Keystone +/– buttons of the remote control you can

fine adjust the projected image.

Moving the projector

1.Press the Standby/On button to switch off the projector. The power will turn off and the Standby/On indicator will blink orange for 1 minute before the standby status will be activated. (The exhaust fan will continue to run for a while for cooling purposes)

2.Wait until the cooling fan has stopped (about 3 minutes after the projector has been switched off) and disconnect the power cord and all other cables.

3.Slide the lens cap back in place to prevent dust, dirt or other contamination from harming or damaging the front of the projector lens when moving the projector.

Note: Never place the projector on the back where the connections are located.

9

Image 9
Contents Philips Multimedia projector LC5141, LC5131 Controls and connections Mouse FCC Warning Introduction Things You Should KnowImportant Safeguards Projector Features Front fig Functional Overview See illustrationsLED Rear figSet Up Positioning the projector and screenMains supply Focus ring Adjusting height and level of the projector Adjusting the focus of the imageProjection angle Skew correctionInserting the batteries in the remote control Using the remote control as PC mouseRemote control mouse functions Minijack female Installation Video/computer cables and adapterVideo/computer cables Optional cables and adapterConnecting to a computer General Installation Connecting to a computerConnecting to PC mouse connector General PC Personal computer / MacintoshConnecting to video equipment General Installation Connecting to video equipmentComposite Video Signal Scart adapter optional OptionalComponent Video Signal YCbCr Preparation General Operation PreparationFeedback messages General explanation On Screen Display menu General explanationOperation Menu structure data input Data mode Normal menu flip cover closedOperation Menu structure video input Video mode Normal menu flip cover closedTip for Windows users Operation Display and picture control/Audio volume controlOperation Display and picture control Operation Display and picture control/Other settings Operation Other settings Maintenance Resetting the lamplife time Problem Troubleshooting