Philips PD7005 user manual Install remote control battery

Page 16

2Connect the supplied AC adaptor to the player and to the AC outlet.

English

»The charge indicator turns on. It takes about 7 hours to fully charge the battery.

»When the battery is fully charged, the charge indicator turns off.

Install remote control battery

Caution

Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Batteries contain chemical substances, they should be disposed of properly.

Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/ hazardouswaste/perchlorate.

For first-time use:

1Remove the protective tab to activate the remote control battery.

To replace the remote control battery:

1Open the battery compartment.

2Insert 1 CR2025 battery with correct polarity (+/-) as indicated.

3Close the battery compartment.

EN 17

Image 16
Contents Register your product and get support at Contents Important Safety Instructions English Hearing safety Recycling Page English Introduction Your portable DVD playerWhat’s in the box Overview of the main unit PWRCH+, CH Overview of remote control Page Get started Charge the battery PreparationInstall remote control battery Connect additional equipment Connect aTVTurn on PlayConnectTV antenna Play discs Select OSD languagePlay options First time settings WatchTVManual search Set timeView program information Access teletext Use the electronic program guideRearrange the channel list Adjust settingsManage channels Product information DttvTroubleshooting